Buffalo TS3400R0804 Инструкция по эксплуатации онлайн [11/179] 106090

11

1 Power Button

To power on, connect the power cable and wait for 10 seconds, then hold down the power button for 1 second. To

power off, hold down the power button for 3 seconds (until it beeps).

2 Info LED

If there is a status message, the amber info LED will light up. Check the LCD panel to see the status message.

3 Error LED

If there is an error, the red error LED will light up. Check the LCD panel to see the error message.

4 LAN1 LED

When LAN port 1 is connected, this LED glows green. It blinks when the connection is active.

8 Function Button

Use this button for Direct Copy, dismounting USB devices, rebuilding RAID arrays, and configuring failover.

9 Drive Lock

Open the front panel with the key to replace hard drives or press the reset button.

10 Init Button

Hold down this button to initialize the TeraStation’s admin username and password, IP address, SSL, and service

port restriction settings to their factory default values. The behavior of this button can be modified in Settings.

11 Status LEDs

Normally, these LEDs blink green when hard drives are accessed. If a drive fails, its LED will turn red or amber.

12 Factory Use Only

Compatible Buffalo USB 3.0 hard drives can be connected. USB hubs are not supported.

16 USB 2.0 Port

Compatible Buffalo USB hard drives, USB flash drives, digital cameras, and USB UPS connection can be connected.

USB hubs are not supported.