Beon BN-8722 Руководство по эксплуатации онлайн [11/16] 890824

11 INSTRUCTION MANUAL

Ironing without steam

• Set the steam supply regulator to the minimum position.

• Select the desired temperature depending on the type of fabric and start ironing after heating

the iron. If necessary, moisten the fabric with a sprinkler.

Steam ironing

• Steam ironing is possible only when the temperature regulator is in the "••" and "•••"

positions. Select the desired position of the temperature regulator and set the steam supply

regulator in the range from the average to the maximum value.

• Steam boost is used at the maximum temperature value. To use this function, briefly press the

corresponding key. Some time should pass between the presses, which is necessary for the

device to gain pressure.

NOTE!

When using steam boost, never direct the steam jet at people or animals, this can lead to burns.

Do not use steam to process clothes worn by people.

• Steam supply may stop when the minimum value of water in the tank is reached. If you need to

continue ironing with steam, turn the steam supply regulator and the thermostat to the

minimum position, and then fill the tank with water as described above.

Vertical steaming

• Set the temperature regulator to the maximum position. Hang your clothes on hangers. Holding

the iron at a distance of 10 cm from the clothes, move it vertically and repeatedly press the

steam stroke key.

Auto Shut Off function (automatic shutdown)

This model is equipped with an automatic shutdown function to prevent the risk of fire. If the

device is left in a horizontal position for 30 seconds or in a vertical position for more than 8 minutes

without movement, an automatic shutdown is triggered. To restore the normal operation of the

iron, it is necessary to change its position - the automatic shutdown function will turn off and

heating will begin to the selected values.

Using the CLEAN function

Using the CLEAN function helps to clean the water vapor system from scale.

• Disconnect the device from the power supply, let the sole cool down if it is hot.

• Set the steam supply regulator to the minimum position. Fill the water tank as described above.

• Connect the iron to the mains, set the maximum temperature and wait for the heating indicator

to go out.

• Disconnect the iron from the power supply. Hold the iron horizontally over the sink or other

container with sufficient volume and temperature resistance to collect boiling water and steam.

• Press the CLEAN function key repeatedly until the water in the iron tank runs out.