Home
Главная
Karcher
Пароочиститель
SC 3 Deluxe (1.513-430.0)
Руководство по эксплуатации Страница: 15

Karcher SC 3 Deluxe (1.513-430.0) Руководство по эксплуатации онлайн [15/186] 897183

English 15

into a drain (without floor cleaning cloth / with accesso-

ries).

Only use the carpet glider with a floor cleaning cloth on

the floor nozzle.

Steam clean with a weak steam stage when using the

carpet glider.

In order to prevent too much moistening and to avoid

the risk of damage due to temperature effects, do not di-

rect the steam continuously onto one spot (maximum

5 seconds).

Do not use the carpet glider on deep-pile carpets.

Fastening the carpet glider to the floor nozzle

1. For fastening the floor cleaning cloth to the floor

nozzle, please refer to chapter Floor nozzle.

Illustration Q

2. Using a little force, allow the floor nozzle to slide into

the carpet glider and engage there.

Illustration R

3. Start cleaning the carpet.

Removing the carpet glider from the floor nozzle

몇 CAUTION

Beware of burns to your feet

The carpet glider can heat up during the steaming pro-

cess.

Do not operate or remove the carpet glider bare-footed

or using open sandals.

Only operate or remove the carpet glider using suitable

footwear.

1. Press the strap on the carpet glider downwards us-

ing your toecap.

2. Lift the floor nozzle upwards.

Illustration R

Care and service

Draining the water reservoir

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

1. Press the On/Off switch.

The device has been switched off.

2. Pull the mains plug out of the socket.

3. Remove the accessories from the accessory hold-

ers.

4. Remove the decalcification cartridge from the de-

vice.

5. Drain the water reservoir.

Illustration S

Replacing the decalcification cartridge

ATTENTION

Device damage and shortened service life

If the replacement intervals (indicator light) for the de-

calcification cartridge are not observed, there is a risk of

device damage and the service life of the device may be

shortened.

Observe the replacement intervals (indicator light).

Note

The replacement intervals depends on the local water

hardness. Areas with hard water (e.g. III/IV) have a

higher replacement interval than areas with soft water

(e.g. I/II).

Indicator lamp at end of the run time

The "decalcification cartridge indicator light " indicates

when the decalcification cartridge has to be replaced:

● The indicator light flashes 2 hours before the run

time expires.

● The indicator light flashes more quickly 1 hour be-

fore the run time expires.

● Once the run time for the decalcification cartridge

has expired, the indicator light and the LED strip

light lights up in continuously red and the pump

switches off automatically in order to prevent device

damage.

Inserting the decalcification cartridge

ATTENTION

Device damage

There is a risk of damage to the device if the used de-

calcification cartridge is re-used.

Work carefully in order to prevent mixing up the cartridg-

es.

Note

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 30 seconds.

1. Press the Off switch.

The device has been switched off.

2. Remove the decalcification cartridge.

3. Insert the new decalcification cartridge.

4. Press the On switch.

The device is switched on.

5. Press and hold the Maximum steam volume and

Reduced steam volume buttons at the same time

until the "Replace decalcification cartridge" goes

out. This means that the reset is complete.

6. Allow the device to heat up.

7. Press and hold the steam lever for approx. 30 sec-

onds to vent the decalcification cartridge.

Setting the water hardness

ATTENTION

Device damage due to calcification

Without a decalcification cartridge, the device may cal-

cify if the water hardness is set incorrectly.

Always work with a decalcification cartridge.

Set the device to the local water hardness.

Set the device to the current water hardness before us-

ing it in an area with a different water hardness (e.g. af-

ter a move).

Note

Your water board or municipal utilities authority can pro-

vide information on hardness of tap water.

The water hardness setting is stored until a new setting

(e.g. after a move) is made. The device is set to the

highest water hardness (level IV) in the factory. The de-

vice indicates the set water hardness with flash pulses.

Karcher SC 3 Deluxe (1.513-430.0) Руководство по эксплуатации онлайн [15/186] 897183

Похожие устройства