Beurer TS15 Руководство по эксплуатации онлайн [13/92] 570631

4.2 Putting into operation

This heated underblanket must be fixed onto the mattress.

1. Leave space for the pillow and place the heated underblanket on the

mattress with the plug-in connector facing the pillow. Here, the plug-in

connector is located on the underside of the heated underblanket.

2. Stretch all of the elastic straps over the corners of the mattress. All 4

corners of the heated underblanket are then fixed onto the mattress.

CAUTION

Regularly check the position of the heated underblanket on the mattress.

The heated underblanket must never be used if it is folded.

After you have fixed the heated underblanket to the mattress, simply put your bed sheet on top as usual so

that the heated underblanket is between the mattress and the bed sheet.

CAUTION

Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or

crease when in use.

• To operate the heated underblanket connect the control to the heated

underblanket by plugging in the connector.

• Then plug in the power plug into the mains outlet.

4.3 Switching on

To switch on the heated underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.

The temperature settings are illuminated when switched on.

4.4 Setting the temperature

Setting 0: OFF

Setting 1: minimum heat

Setting 2: medium heat

Setting 3: maximum heat

NOTE:

•

The fastest way to warm up the heatd underblanket is to initially set the highest temperature setting.

•

We strongly recommend switching on the heated underblanket approx. 30 minutes before going to

bed and covering it with the quilt to prevent the warmth from escaping.

WARNING

If the heated underblanket is being used over several hours, we rec-

ommend that you set the lowest temperature setting on the control to

avoid the body overheating and thereby any potential burns to the skin

or heat stroke.

4.5 Switching off

To switch off the heated underblanket, set the slider for ON/OFF and temperature settings to the “0” (OFF)

position. The temperature settings are then no longer illuminated.