Denzel ID-750 Руководство по эксплуатации онлайн [10/28] 662706
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Denzel ID-750 Руководство по эксплуатации онлайн [10/28] 662706

Denzel ID-750 Руководство по эксплуатации онлайн [10/28] 662706
10
ELECTRIC IMPACT DRILL
EN
Before getting started, you must:
•
inspect the tool and make sure it is complete and there is no external damage;
•
make sure that the power switch is working correctly;
•
after transportation in winter conditions before switching on, keep the machine at room temperature until
the condensate is completely dry.
Getting started, you must:
•
install the side handle in a comfortable work position;
•
check the reliability of xing of the tooling in chuck;
•
make sure that the power switch is in the “O” position, and then connect the machine to the power supply.
To turn on the machine, it is necessary to press the switch key 8 (pic. 1). If necessary, the key of the power switch 8
(pic. 1) can be locked in the "on" position, for this, while pressing the 8 key, press the button 5 (pic. 1) and the key
will be xed. To turn o the machine, press the 8 key again.
Recommendation: Try out the operation of xing the power key before connecting the machine to the power
supply.
While working:
•
do not overload the machine, watch for the engine housing heat up, take breaks in time;
•
do not allow mechanical damage, shock, falling of the tool on hard surfaces, etc .;
•
protect the machine from exposure to intense heat sources or chemically active substances, as well as from
the ingress of liquids and foreign solid objects inside the machine;
•
ensure eective removal of processing products from the cutting zone;
•
do not block or obstruct the ventilation openings in the machine housing;
•
turn o the machine using the switch before connecting / disconnecting from the power supply.
At the end of work:
•
disconnect the tool from the mains, making sure the switch is in the “o” position;
•
clean the machine and accessories from dirt.
Recommendations for use
Before you start processing a part, you must secure it, especially if it has light weight.
When drilling metal it is recommended to use lubricating and cooling uids in the cutting zone.
When drilling holes of signicant diameter, it is recommended to rst drill a hole of a smaller diameter, and then
drill it to the required.
When drilling through holes in metals or plastics, be careful when the drill leaves the material – tangible jerk
possible, reduce feed force.
Do not overheat external machine parts during long work. If there is an excessive heat, stop working, let the tool
work without load for 1...2 minutes for engine cooling, turn o the engine and take a break until the gear housing
becomes cool.
Do not allow the machine work when there is extraneous or uncharacteristic noise in the engine or gear. When
there are noises turn o the tool and contact an authorized service.
Do not operate the machine when visible flashes appear in the engine ventilation openings, stop working
and contact the service center for diagnostics and, possibly, replacement of carbon brushes.
NOISE AND VIBRATION
Noise and vibration characteristics are given in the table №1.
However, if the Impact Drill will be used for other work with the use of working tools, not provided by the manufacturer,
or maintenance will not meet the requirements, then the vibration level may be dierent.
ATTENTION!
Always use personal ear protection.

Похожие устройства

Скачать