Home
Главная
Brayer
Паровая Станция
BR4157
Инструкция по эксплуатации Страница: 11

Brayer BR4157 Инструкция по эксплуатации онлайн [11/38] 904128

• To resume ironing, press the button (13 or 15) or the

steam supply button (12), wait until the soleplate (14)

heats up, and continue ironing.

SELF-CLEAN FUNCTION

• To extend the service life of the steam station

and maintain good steam performance, it is

recommended to ll the tank (2) with water cleaned

with domestic lters.

• If tap water is hard, it is recommended to mix it with

distilled water in proportion 1:1. If tap water is too

hard, mix it with distilled water in proportion 1:2 or

use distilled water only.

Note: do not pour vinegar or any other descaling agents

into the tank (2).

• Make sure that the water tank (2) is lled with water.

• Insert the power plug into the mains socket, you will

hear a sound signal and the button (15) light indicator

will light up.

• Switch the device on by pressing and holding the

button (13 or 15) for 2 seconds. You will hear a sound

signal, and the indicator of the button (13) will light

up and ash.

• After the iron soleplate (14) heats up, the button (13)

indicator will glow constantly.

• Hold the iron above the sink, simultaneously press

and hold the button (13) and the steam supply button

(12) for 3-4 seconds, the self-clean function indicator

(20) «

» will light up on the display (16).

• Press and lock the steam supply button (12), the

pump will switch on for maximum water supply,

the steam, mineral deposits and hot water will be

released intensively from the soleplate (14) openings.

• After approximately 1-2 minutes, unlock and release

the steam supply button (12).

• Once again, simultaneously press and hold the

button (13) and the button (12) for 3-4 seconds, the

self-clean function indicator (20) «

» on the display

(16) will go out.

• Switch the steam station o󰀨 by pressing and holding

the on/o󰀨/mode selection button (15) «

», and

remove the power plug from the mains socket.

CLEANING AND MAINTENANCE

• Before cleaning the steam station make sure that it is

switched o󰀨 and the iron is cold and the power plug

is not connected to the mains socket.

• Wipe the steam station body (1) and the iron with a

slightly damp cloth, and then wipe them dry.

• You can remove the mineral deposit from the iron

soleplate (14) with a cloth soaked in table vinegar.

• Do not use abrasives or solvents to clean the steam

station body (1), the iron body and the soleplate (14).

• Avoid contact of the iron soleplate (14) with sharp

metal objects, as well as with metal buttons, zippers

etc.

• Do not immerse the steam station body, the iron,

the power cord and the power plug into water or any

other liquids.

Brayer BR4157 Инструкция по эксплуатации онлайн [11/38] 904128

Похожие устройства