Home
Главная
Brayer
Паровая Станция
BR4157
Инструкция по эксплуатации Страница: 7

Brayer BR4157 Инструкция по эксплуатации онлайн [7/38] 904128

• If the power cord is damaged, it should be replaced

by the manufacturer, a maintenance service or

similar qualied personnel to avoid danger.

• Do not repair the unit by yourself. Do not

disassemble the unit by yourself, if any malfunction

is detected, and after the unit was dropped, unplug it

and apply to the service center.

• To avoid damages, transport the unit in the original

package.

• Keep the unit in a dry cool place out of reach of

children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE

ONLY, DO NOT USE THE UNIT FOR COMMERCIAL

OR LABORATORY PURPOSES.

BEFORE THE FIRST USE

After the unit’s transportation or storage at negative

temperature, unpack it and wait for at least 3 hours

before using.

• Unpack the steam station and remove any packaging

materials and advertising stickers.

• If there is a protective lm on the steam station

soleplate (14), remove it.

• There may be water drops in the tank (2), as the

steam station has undergone factory quality control.

• Read the safety measures and operating

recommendations.

• Check the delivery set.

• Examine the unit for damages, in case of damage do

not plug it into the mains.

• Make sure that specied specications of power

supply voltage of the unit correspond to the

specications of your mains. When using the unit in

the mains with 60 Hz frequency, the unit does not

need any additional settings.

• Clean the steam station body and the iron soleplate

(14) with a slightly damp cloth, then wipe it dry.

WATER SELECTION

• Use tap water to ll the water tank (2).

• We recommend to ll the tank (2) with water

additionaly cleaned with domestic lters.

• If tap water is hard, it is recommended to mix it with

distilled water in proportion 1:1. If tap water is too

hard, mix it with distilled water in proportion 1:2 or

use distilled water only.

FILLING THE WATER TANK

• Take the handle (3), press on the lock (4) and

remove the water tank from the steam station body.

• Open the water inlet lid (5).

• Pour water into the tank (2) through the lling hole,

close the lid (5).

• Install the tank (2) back to its place until the lock

(4) clicking. Make sure that the tank (2) is installed

properly and xed.

Brayer BR4157 Инструкция по эксплуатации онлайн [7/38] 904128

Похожие устройства