Delfa NDK20 Инструкция по эксплуатации онлайн [4/6] 116892

TURNING ON THE DEVICE

• Insert the plug in the suitable socket, and adjust temperature control to the highest level

(i.e. turn the handle clockwise all the way in).

• Note: In order to avoid contact fault which may overload the socket and may lead to the

ignition of the plug, when using the socket for the first time or when frequently removing

the plug from the socket make sure that the plug is properly inserted in the socket.

TEMPERATURE ADJUSTMENT

• If you feel that the temperature is too high when using this device, then you may lower the

temperature the following way:

• Turn the temperature controller counter-clockwise from its maximum position. If you still

want to reduce the temperature, continue turning the switch handle. After this procedure

the device will work with breaks.

TURNING OFF THE DEVICE

• In order to turn off the device move the power controller to 0 position or unplug the power

cord from the socket.

NOTES:

CLEAN AND CARE

• The room must be properly sealed, if not, using of oil heater will not make good result

because of heat leakage.

• After use, turn the thermostat to minimum position and unplug the appliance from power

supply.

• The convector should be cleaned regularly to wipe out the dust on the surface of fins. As

this may result the radiating efficient.

• Unplug from the power supply and allow the appliance to cool down.

• Wipe out with a soft damp cloth. Do not use detergent or abrasives.

• Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty,

because of damage of the paint coat.

STORAGE

• Switch off and unplug the appliance. Ensure the convector is completely cool.

• Complete all requirements of chapter CLEAN AND CARE.

• Reel on the power cord.

• Keep the appliance in a dry cool place.