Texas XT 50 TR/WE 90066038 Инструкция по эксплуатации онлайн [26/74] 11900

Charging during the season

The battery is charged a little during use, buy it will likely be necessary to charge the

battert a couple of times during the season - depending if the number of start/stops of

the engine. Put it for charging for around 12 hours.

Storage of battery

The battery must always be stored dry and warm during the winter. Never expose it for

low temperatures. It is recommende to take out the battery from the box (loosen the

screw), charge it fully and place it indoor.

Charge it 1-2 times during the winter to make sure the battery keeps it full capacity.

Incorrect storage kan damage the battery, and is not covered by warranty.

Fuel primer

It is important to pump the primer 1-2 times before the engines is started.

This gives an easier start.

If it should happend, that the primer is pumped too much (engine drowned), the solution

is to pull the start cord several times until the engine starts. Do not use the electric start

function in this case. Let the engine running for one minutte before it is stopped.

Cable adjustment

Both cables can be adjusted.

The stop cable can be adjusted at the engine. The cable for the self-propelling function

can be adjusted using the cable near the top handle.

Height adjustment

The lawn mower comes with central height adjustment.

Use the handle near the right rear wheel to adjust the cutting height.

Oil change

The oil must be changed after the first 5 hours of use. After that the oil must be changed at

least once a year.

1. Let the engine run for 5 minutes to warm up the oil. This makes it run easier and

make the oil change more complete.

2. Turn off the engine after 5 minutes. Take off the spark plug cap. Unscrew the

cork for the drain plug. Theo oil now runs out of the engine. Keep a suitable

container ready to collect the oil.

NOTE that the engine may only be tilted backward at an angle of max 45

degrees.

Refit the drain plug and pour fresh oil into the engine.

3. This is done by removing the oil stick and filling with correct amount of oil.

4. Mount the spark plug cap.