Home
Главная
Sea-Doo
Гидроцикл
RXT iS 2009
Инструкция по эксплуатации Страница: 21

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [21/555] 12044

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [21/555] 12053

INTRODUCTION

3. Twist bolt when inserting it to improve thread

conformation.

NOTE: NOT intended for engine stud repairs.

Repair of Small Holes/Fine Threads

Option 1: Enlarge damaged hole, then follow

STANDARD THREAD REPAIR

procedure.

Option 2: Apply FORM-A-THREAD on the screw

and insert in damaged hole.

Permanent Stud Installation (Light Duty)

1. Use a stud or thread on desired length.

2. DO NOT apply release agent on stud.

3. Do a STANDARD THREAD REPAIR.

4. Allow to cure for 30 minutes.

5. Assemble.

Gasket Compound Application

lmr2007-040-006_a

1. Proper

strength Loctite

2. Loctite Primer N (P/N 293 800 041) and Gasket Eliminator 518

(P/N 293 800 038) on both sides of gasket

3. Loctit

e Primer N only

1. Remove old gasket and other contaminants

with

LOCTITE CHISEL (GASKET REMOVER)

(P/N 413 708 500)

. Use a mechanical mean

if necessary.

NOTE:

Avoid grinding.

2. Clean both mating surfaces with solvent.

3. Spray Loctite Primer N on both mating surfaces

and on both sides of gasket. Allow to dry 1 or

2 minutes.

4. Appl

LOCTITE 518 (P/N 293 800 038) on both

side

s of gasket, using a clean applicator.

5. Place gasket on mating surfaces and assemble

immediately.

NOTE: If the cover is bolted to blind holes (above),

apply proper strength Loctite in the hole and on

threads. Tighten.

If holes are sunken, apply proper strength Loctite

on bolt threads.

6. Tighten as usual.

Threadlocker Application for Mounting

on Shaft

Mounting with a Press

A00A3UA

1. Bearing

2. Proper strength Loctite

3. Shaft

1. Clean sha

ft external part and element internal

part.

2. Apply a strip of proper strength Loctite on shaft

circumference at insert or engagement point.

NOTE: Retaining compound is always forced out

when applied on shaft.

3. DO NOT us

e antiseize Loctite or any similar

product

4. No curing period is required.

Mounting in Tandem

1. Apply r

etaining compound on internal element

bore.

2. Continue to assemble as shown above.

XVIII smr2009-011

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [21/555] 12044

Похожие устройства