Home
Главная
Sea-Doo
Гидроцикл
RXT iS 2009
Инструкция по эксплуатации Страница: 32

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [32/555] 12044

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [32/555] 12053

Section 01 MAINTENANCE

Subsection 03 (STORAGE PROCEDURE)

NOTICE

Never cut the locking ties of ignition

coil connectors. This would allow mixing the

wires between cylinders.

3. Clean ignition coil areas to avoid falling dirt into

cylinder.

4. Remove ignition coils.

5. Unscrew spark plugs.

6. Using an ignition coil as a puller, remove spark

plugs.

smr2006

-016-030_a

1. Ignition coil

2. Spark plug

7. Spray X

PS LUBE (P/N 293 600 016)

into each

spark p

lug hole.

8. Crank the engine a few turns to distribute the

oil on cylinder wall.

NOTE: To crank engine, use the drowned mode

to avoid injecting fuel. Fully depress throttle lever

and hold for cranking engine.

9. Apply

LOCTITE 767 (ANTISEIZE LUBRICANT)

(P/N 2

93 800 070)

on spark plug threads then

rein

stall them.

10. Prior to inserting the ignition coil to its loca-

tion, apply some

DOW CORNING 111 (P/N 413

707 000)

around the seal area that touches the

spark plug hole.

11. Reinstall ignition coils.

12. Ens

ure the seal seats properly with the engine

top

surface.

13. Reconnect ignition coil connectors.

14. Install all other removed parts.

ELECTRICAL SYSTEM

Battery Removal

For battery removal, cleaning and storage, refer to

CHARGING SYSTEM

subsection.

VEHICLE

Bilge Cleaning

Clean the bilge with hot water and mild detergent

or with bilge cleaner.

Rinse thoroughly.

Lift front end of watercraft to completely drain

bilge.

Body and Hull Cleaning

Wash the body with soap and water solution (only

use mild detergent). Rinse thoroughly with fresh

water. Remove marine organisms from the hull.

NOTICE

Never clean body parts or hull with

strong detergent, degreasing agent, paint thin-

ner, acetone, etc.

Replace damaged labels/decals.

Body Repair

If any repair is needed, refer to

BODY

subsection.

Anticorrosion Treatment

Wipe off any residual water in the engine compart-

ment.

Spray

XPS LUBE (P/N 293 600 016) over all metallic

components in engine compartment.

Vehicle Protection

Apply a good quality marine wax on body and hull.

The seat should be left partially open during stor-

age. This will prevent engine compartment con-

densation and possible corrosion.

If the watercraft is to be stored outside, cover it

with an opaque tarpaulin to prevent sun rays and

grime from affecting the plastic components, wa-

tercraft finish as well as preventing dust accumu-

lation.

NOTICE

The watercraft should never be left

in water for storage, stored in direct sunlight

or stored in a plastic bag.

smr2009-014 9

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [32/555] 12044

Похожие устройства