Home
Главная
Sea-Doo
Гидроцикл
RXT iS 2009
Инструкция по эксплуатации Страница: 35

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [35/555] 12044

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [35/555] 12053

Section 01 MAINTENANCE

Subsection 04 (SPECIAL PROCEDURES)

Supercharger Servicing

If there was water in the oil or in the supercharger

inlet hose, it is recommended to take the super-

charger apart, dry all the components, replace the

slip clutch needle bearings and shaft ball bearings.

Refer to

SUPERCHARGER

section.

Engine Oil and Filter Replacement

If water gets in the oil (oil will be milky), change

the engine oil and filter as per procedure further

in this subsection.

Remove the deck extension. Refer to

BODY

sub-

section.

1. Using the

SUCTION PUMP (P/N 529 035 880),

siphon the contaminated oil from the engine

reservoir through dipstick hole.

5290358802

NOTICE

Never crank or start engine when

siphon tube is in dipstick hole. Never start

engine when there is no oil in engine.

2. Remove the suction pump tube from the dip-

stick hole.

3. Fully depress throttle lever and HOLD it for

cranking.

4. Crank the engine for 5 seconds.

5. Remove the oil filter cap and the oil filter. Refer

LUBRICATION SYSTEM

subsection.

6. Again, siphon the contaminated oil from the oil

filter reservoir.

7. Remove valve cover. Refer to

CYLINDER

HEAD

subsection.

smr2006-006-001_a

1. Valve cover

8. Put a tape at 400 mm (16 in) from the end of the

suction pump tube.

9. Insert the tube in the PTO area until the tape

reach the cylinder-block edge. Then, siphon

contaminated oil out.

smr2006-006-003_a

TYPICAL

1. Suction pu

mp tube with tape

2. Edge of cylinder-block

10. Remove the suction pump tube.

11. Reinstall valve cover.

12. Install a

NEW oil filter and reinstall the oil filter

cap.

13. Fill up the reservoir with fresh oil.

14. Proceed with the boil out procedure:

NOTE: Th

e boil out procedure is intended to evap-

orate th

e water contained in the oil.

Boil Out Procedure in a Test Tank or Tied to a

Trailer

with Watercraft in Water

1. Connect the vehicle to B.U.D.S. to monitor the

coolant temperature. It must exceed 100°C

(212°F) in order for the water boil out. Once

the boil point is reached, it won't take long to

evaporate the water.

2. Run the engine for 5 minutes at 3500 RPM.

WARNING

Make sure to safely secure the watercraft.

3. With the engine still running at 3500 RPM, in-

stall a

LARGE HOSE PINCHER (P/N 529 032 500)

to the coolant line going to the oil cooler.

12 smr2009-015

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [35/555] 12044

Похожие устройства