![Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [115/555] 12053](/img/pdf.png)
Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [115/555] 12053
![Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [115/555] 12053](/views2/1012781/page115/bg73.png)
Section 02 ENGINE
Subsection 08 (LUBRICATION SYSTEM)
NOTICE
Never crank or start engine when
suction pump tube is in dipstick hole. Never
start engine when there is no oil in engine.
NOTE: So that suction pump tube is located at
the proper height to siphon oil, it is suggested
to put some electrical tape on tube at 475 mm
(18-11/16 in) from its end. Then, insert the tube
until you reach the tape.
2
R1503motr150A
1
TYPICAL
1. Suctio
n pump
2. Suction pump tube in dipstick hole
Pull suction pump tube out of dipstick hole then
crank engine (do not start) while in engine drown
mode (fully depress throttle lever and HOLD, then
crank engine).
Crank engine for 10 seconds. Siphon oil again.
Repeat the crank-siphon cycle 2 - 3 times.
Refil
l engine with the recommended oil, see
REC-
OMMEN
DED OIL
in this subsection.
Reinstall oil filler cap and dipstick.
Replace
OIL FILTER
, see procedure in this sub-
section.
OIL FILTER
Oil Filter Removal
Remove:
– Oil filter screw
–Oilfi
lter cover
–Oilfilter.
smr2009-023-003_a
1. Oil filter screw
2. Oil filter cover
3. Oil filter
NOTE: No tools are required to remove the oil fil-
ter cover, as it will pull off when the oil filter screw
is unscrewed.
Place rags in filler area to prevent spillage. If
spillage occurs, clean immediately with the
PUL-
LEY FLANGE CLEANER (P/N 413 711 809)
to prevent
stains.
Oil Filter Inspection
Check oil filter cover O-rings and oil filter screw
O-ring, change if necessary.
Check and clean the oil filter inlet and outlet area
for dirt and other contaminations.
smr2009-023-004_a
1. Inlet bore from the oil pump to the oil filter
2. Outle
t bore to the engine oil providing system
Oil Filter Installation
For in
stallation, reverse the removal procedure.
Pay at
tention to the following details.
Install a NEW oil filter.
Install O-ring on oil filter cover.
92 smr2009-023
Похожие устройства
- Craftsman 38901 Инструкция по эксплуатации
- Samsung GW77NMR-X Инструкция по эксплуатации
- Delonghi ESAM 6620 Инструкция по эксплуатации
- Yamaha CPX-700 SDB Инструкция по эксплуатации
- Haier JC-110GDD Инструкция по эксплуатации
- Panasonic SC-HT05 Инструкция по эксплуатации
- Can-Am Spyder RT SE5 2010 Инструкция по эксплуатации
- Delonghi KG 49 Black Инструкция по эксплуатации
- Partner P40-450C 9620001-12 Инструкция по эксплуатации
- Samsung CE-2738 NR Инструкция по эксплуатации
- Haier JC-160GD Инструкция по эксплуатации
- Yamaha FX-370C Инструкция по эксплуатации
- Can-Am Spyder RT SM5 2010 Инструкция по эксплуатации
- Panasonic SC-DT310 Инструкция по эксплуатации
- Simplicity ERDS16550 881247 Инструкция по эксплуатации
- Delonghi KG 40 Black Инструкция по эксплуатации
- Samsung GE89ASTR Инструкция по эксплуатации
- Yamaha FX-370C BL Инструкция по эксплуатации
- Haier ZW-266 Инструкция по эксплуатации
- Opel Vectra B Инструкция по эксплуатации