Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [124/555] 12053

Section 02 ENGINE

Subsection 08 (LUBRICATION SYSTEM)

R1503motr131A

1. PTO housing surface

2. Vernier depth gauge

R1503motr132A

1. Oil pump outer rotor surface

2. Vernier depth gage

Difference between pump housing and outer ro-

tor should not exceed 0.1 mm (.004 in). If so, re-

place the complete oil pump assembly.

NOTE: When the axial clearance of the oil pump

shaft increases, the oil pressure decreases.

Check the inside of oil pump housing and its cover

for scoring or other damages and replace if dam-

aged.

Oil Pressure Pump Installation

For installation, reverse the removal procedure.

Pay attention to the following details.

NOTE: Never use oil in the press fit area of the

rotary seal.

Push water/oil pump shaft oil seal in place by us-

ing thumb.

R1503motr128A

1. Oil seal

Install the new rotary seal by using the WATER

PUMP SEAL PUSHER (P/N 529 035 823)

529035823

NOTICE

Never use a hammer for the rotary

seal or water/oil pump shaft installation. Only

use a press to avoid damaging the ceramic

component.

R1503motr141A

TYPICAL

1. Rotary seal

2. Rotary seal pusher

Install the OIL SEAL GUIDE (P/N 529 035 822) on the

end of coolant/oil pump shaft.

smr2009-023 101