Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 193

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [193/555] 12053

Section 02 ENGINE

Subsection 11 (CYLINDER BLOCK)

Clean oil passages and make sure they are not

clogged.

Clean all metal components in a solvent.

Cylinder block mating surfaces are best cleaned

using a combination of the

LOCTITE CHISEL (GAS-

KET REMOVER) (P/N 413 708 500)

and a brass brush.

Brush a first pass in one direction then make the fi-

nal brushing perpendicularly (90°) to the first pass

(cross hatch).

NOTICE

Do not wipe with rags. Use a new

clean hand towel only.

IMPORTANT: When beginning the application of

the crankcase sealant, the assembly and the first

torquing should be done within 10 minutes. It is

suggested to have all you need on hand to save

time.

NOTE: It is recommended to apply this specific

sealant as described here to get an uniform appli-

cation without lumps. If you do not use the roller

method, you may use your finger to uniformly dis-

tribute this sealant.

Apply

LOCTITE 5910 (P/N 293 800 081) on mating

surfaces.

NOTICE

Do not use other products to seal

crankcase. Do not use an activator with the

Loctite 5910. Using other products or non sil-

icone-based sealant over a previously sealed

crankcase with Loctite 5910 will lead to poor

adhesion and possibly a leaking crankcase.

NOTE: Refer to the product label for the sealant

curing time. Respect the manufacturer's recom-

mendations prior to start engine.

Use a plexiglass plate and apply some sealant

on it. Use a soft rubber roller of 50 mm - 75 mm

(2 in - 3 in) available in arts products suppliers for

printmaking, roll the sealant to get a thin uniform

coat on the plate (spread as necessary). When

ready, apply the sealant on crankcase mating

surfaces.

F12R17A

Do not apply in excess as it will spread out inside

crankcase.

Tighten cylinder block screws as per following pro-

cedure:

Apply

LOCTITE 243 (BLUE) (P/N 293 800 060) on

screw threads.

Torque cylinder block screws no. 3 to 40 N•m

(30 lbf•ft) following sequence 1 to 8 and then to

55 N•m (41 lbf•ft) (repeat sequence).

Torque cylinder block screws no. 7 to 23 N•m

(17 lbf•ft) following sequence 9 to 23.

3 1 7

R1503motr06B

235 21 17 18 19 2022

16 15 14 9 2 10 11 12 136 84

NOTE

: Before continuing the assembly process,

the a

xial clearance of balancer shaft and crank-

shaf

t has to be checked. Refer to

CRANKSHAFT

and

ALANCER SHAFT

in this subsection for the

proc

edure.

170 smr2009-026

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [193/555] 12053

Похожие устройства