Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 293

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [293/555] 12053

Section 04 FUEL SYSTEM

Subsection 03 (FUEL TANK AND FUEL PUMP)

smr2009-031-017_b

1. Quick connect fitting (high pressure fuel hose)

2. Vent hose

3. Harness connector

Disconnect filler hose from fuel tank.

NOTE: Removing retaining screws of the filler

neck may help to disconnect hose from fuel tank.

smr2009-031-026_a

1. Filler

hose

2. Retaining clamp

NOTE: Take note of wiring harness, hoses and

cable routing for proper reinstallation. Also note

method used for securing with locking ties.

Detach fuel tank retaining straps.

Remove

fuel tank from the vehicle.

Remove fuel pump as necessary. Refer to

FUEL

PUMP

in this subsection.

Inspect hull and flotation foams for wear.

Fuel Tank Installation

NOTE: Apply torque values as specified in the ex-

ploded view.

Reinst

all fuel pump if it was removed. Refer to

FUEL P

UMP

in this subsection.

Ensure flotation foams are properly positioned.

Insert fuel tank in hull.

Place fuel tank retaining strap ends in anchoring

clips. Temporarily use tape to hold straps on the

top of fuel tank.

smr2009-0

31-027_a

1. Fuel tank retaining strap

2. Clip anchor securing strap to hull

Secure a l

ong retaining strap end with a short

strap end

on top of fuel tank.

NOTE: Fuel tank retaining straps are paired one

long and one short together, and two consecutive

pairs are installed in opposing directions to stag-

ger the metal retainers. See following illustration.

smr2008-022-016_a

REAR FUEL TANK RETAINING STRAPS ILLUSTRATED

1. Long retaining straps

2. Short retaining straps

Properly secure wire harness, cables and hose as

prior to removal using appropriate locking ties.

Install fuel tank filler hose as shown. Torque re-

taining clamps as per exploded view.

270 smr2009-031

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [293/555] 12053

Похожие устройства