Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [31/555] 12053
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [31/555] 12053

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [31/555] 12053
Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURE)
smo2009-002-151_a
1. Hose alignment lines
2. Hose clamp
3. Intercooler outlet hose
4. iS module
4. Start engine and rev up to 4000 RPMs several
times. Water will be expelled from intercooler.
NOTE: Prevent air intake system from aspirating
foreign objects which may cause severe engine or
damage.
5. Stop engine.
6. Install intercooler outlet hose.
Exhaust System Protection
The exhaust system is self draining, but the ex-
haust manifold needs to be drained to avoid dam-
ages if watercraft is stored in area where freezing
weather is present.
Using the flushing connector located at the rear of
vehicle, inject pressurized air (at 380 kPa (55 PSI))
into system until there is no more water flowing
from jet pump.
smr2009-021-004_a
1. Flus
hing connector
The following hose can be fabricated to ease
draining procedure.
smo2008-001-053_a
TYPICAL
1. Flushing adaptor (P/N 295 500 473)
2. Hose 13 mm (1/2 in)
3. Air hose male adapter
NOTICE
Failure to drain the exhaust mani-
fold may cause severe damage to this compo-
nents.
Engine Coolant Replacement
Antifreeze should be replaced every 200 hours or
every two years to prevent antifreeze deteriora-
tion.
NOTICE
Failure to replace the antifreeze as
recommended may allow its degradation that
could result in poor engine cooling.
If coolant is not replaced, test the coolant density
using an antifreeze hydrometer.
Replace coolant if necessary. For the coolant re-
placement procedure, refer to
COOLING SYSTEM
subsection.
NOTICE
Improper antifreeze density might
lead coolant to freeze if vehicle is stored in
area where freezing point is reached. This
would seriously damage the engine.
Engine Internal Lubrication
Engine must be lubricated to prevent corrosion on
internal parts.
Lubrication of the engine is recommended at the
end of the season and before any extended stor-
age period to provide additional corrosion protec-
tion. This will lubricate the engine intake valves,
the cylinders and the exhaust valves.
To lubricate the engine, proceed as follows:
1. Open seat and remove the rear ventilation box.
2. Disconnect ignition coil connectors.
WARNING
When disconnecting coil from spark plug, al-
ways disconnect coil from main harness first.
Never check for engine ignition spark from
an open coil and/or spark plug in the engine
compartment as spark may cause fuel vapor
to ignite.
8 smr2009-014

Похожие устройства

Скачать