Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [351/555] 12053

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [351/555] 12053
Section 05 ELECTRICAL SYSTEM
Subsection 06 (DIGITALLY ENCODED SECURITY SYSTEM (D.E.S.S.))
If programming is complete, write the changes to
the ECM. Refer to
WRITING CHANGES TO ECM
in this subsection.
Erasing All Keys
Click on Erase All Keys button at bottom of
screen.
smr2009-035-004_b
1. Click on this button
NOTE: No message will be displayed in B.U.D.S.
When done, add at least a new key to the vehicle.
Refer to
ADDING A KEY
in this subsection.
If programming is complete, write the changes to
the ECM. Refer to
WRITING CHANGES TO ECM
in this subsection.
Writing Changes to ECM
Save the changes made in B.U.D.S. into the ECM
as follows.
Briefly press the START button to prevent ECM
communication interruption during the write
process. Do not hold START button to avoid
engine cranking.
Click the Write Data button.
vmr2006-012-100_ben
NOTE: I
f for some reason the writing operation
fails,
exit B.U.D.S. Restart B.U.D.S. and reenter all
the pre
viously lost information.
After the write operation, remove key from
D.E.S.S. post.
Try the key(s) on the watercraft.
Setting Maximum Speed for Learning
and Rental Keys
NOTE
The maximum s
peed setting chosen will be
applicable to any programmed Learning or Rental
keys.
Changing key setting is only available when the
engine is not running.
A programmed normal D.E.S.S. key is required to set
the Learning or the Rental key.
To change Le
arning or Rental Key settings, carry
out the foll
owing:
1.BrieflypresstheSTARTbuttontowakeupthe
electrical system.
sdd2009
-001-019_e
1. START button
2. Wait for the information center to complete its
self-test.
3. Install a programmed normal D.E.S.S. key to
watercraft D.E.S.S. post.
4. Press
the MODE button repeatedly until KEY
MODE i
s visible in the information center.
328 smr2009-035
Скачать