Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 421

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [421/555] 12053

Section 06 STEERING AND PROPULSION

Subsection 02 (iBR AND VTS)

iBR GATE SUPPORT PLATES

iBR Gate Support Plate Removal

NOTE: The following steps must be carried out

when removing the LH or RH support plates.

1. Open the boarding platform.

2. Remove the following listed items, see proce-

dures in this subsection:

– iBR gate, VTS trim ring, and the steering noz-

zleasanassembly

–iBR"U"arm.

RH Support Plate Removal

1. Remove the RH storage bin, refer to the

BODY

subsection.

2. Remove the battery, refer to

CHARGING SYS-

TEM

subsection.

3. Disconnect the exhaust hose from the RH inner

support plate.

smr2009-043-001_a

1. Exhaust hose

2. Clamptoloosen

4. Remove and discard the 2 hexagonal screws

securing the outer support plate to the inner

support plate.

smr2009-043-002_a

1. Support plate retaining screws

NOTE: Two locking tabs on the inner plate locks

it to the outer plate exhaust nozzle.

5. Using a small screwdriver or a scriber, lift the

upper locking tab slightly to help release the

plates and avoid breaking the tabs.

smr2009-043-003_a

1. Locking t

ab x2 (top and bottom)

6. Carefully pull the RH inner support plate off the

outer plate.

smr2009-043-004_a

1. RH inner support plate

7. Pull the outer plate off the hull.

LH Support Plate Removal

1. Remove the iBR actuator, refer to procedure in

this subsection.

2. Cut the locking ties and disconnect the 2 bailer

hoses from the jet pump venturi.

398 smr2009-037

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [421/555] 12053

Похожие устройства