Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 475

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [475/555] 12053

Section 07 BODY AND HULL

Subsection 01 (SUSPENSION (iS))

transmit it through the CAN bus. The module will

react to the command, carry out the function, and

transmit the result back through the CAN bus.

The gauge will use the signals from the switches

and the transmitted information from the other

modules, convert them to an indication, and

cancel the command signal it sent out once the

function has been carried out.

Command signals from the iS button are translate

and sent to the iS module.

NOTE: The above stated voltages vary slightly de-

pending on the actual voltage applied to the circuit

and the current flow through the diodes. When

using a Fluke 115 multimeter for testing in diode

test mode, the voltage and current applied by the

multimeter are lower than in circuit. The quality

of probe contact, the actual probes and leads, and

the precision of the meter calibration will all affect

the results, which will most likely be slightly lower

than nominal values stated.

iS Button Operation Test

If iS UP or DOWN switches do not allow the se-

lection, test the switches as follows:

– Check the iS button operation using B.U.D.S.

software. Refer to

COMMUNICATION TOOLS

AND B.U.D.S. SOFTWARE

subsection to con-

nect B.U.D.S.

– Check if there is any occurred or active fault

code(s). If not, proceed with the following test.

– Depress the iS UP switch on steering and check

if the suspension UP light turn on.

– Repeat with the iS DOWN switch. Suspension

Down light should turn on.

smr2009-041-051_a

MONITORING AND CLUSTER TABS

1. Suspe

nsion UP light

If one switch does not function, replace iS button.

If bot

h switches stay off, do the following to verify

the ci

rcuit.

1. Remove the gauge support cover.

2. Disconnect the gauge connector.

smr2009-042-002_a

1. Gauge connector

2. Slide out gauge connector tab to unlock

3. Using the FLUKE 115 MULTIMETER (P/N 529 035

868)

set to the diode test function, test the iS

Up or DOWN switches as per following tables.

NOTE: In diode test mode, the multimeter will

test the voltage drop through the diodes.

vmr2006-020-005

452 smr2009-041

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [475/555] 12053

Похожие устройства