Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [519/555] 12053

Section 07 BODY AND HULL

Subsection 02 (BODY)

pieces evenly. Try to work quickly, you may only

have 15 or 20 minutes. You may clean the brush

with acetone.

Wait until the repair has hardened before moving

on to the interior repair. If the size of the opening

is too large for the pieces to maintain the proper

shape, you will have to use a backing support. It

is a shaped piece of cardboard that fits flush to the

interior surface and has a plastic layer on the repair

side. It is held in place by tape or a support.

Inside: Wipe down the area with acetone on a

cloth. Apply the same procedure as for outside

repair when laminating the alternating pieces

of fiberglass material. If a backing support was

used, remove it before starting the repair. After

the area has hardened, remove sharp edges of

material from surface. If required paint the sur-

face.

Sanding

Outside: This surface will have to be prepared for

application of gelcoat. The size of the area will

determine the gelcoating procedure to be used.

Refer to the

MINOR GELCOAT FRACTURES RE-

PAIR

Buffing and Waxing

Refer to the

BUFFING AND WAXING

MINOR

GELCOAT FRACTURES REPAIR

496 smr2009-042