Texas TX 501TG Инструкция по эксплуатации онлайн [19/57] 12928

4. Fasten the cables using the cable clips supplied.

Figures 11 and 12.

5. Fit the side guards using the bolts and nuts supplied.

Figure 4.

6. Fit the bumper using the bolts and nuts supplied.

Figure 5.

7. Fit the blades using the split pins supplied.

Make sure the cutting edge of the blade faces forward, as shown in figure 6a.

Figures 5 and 6.

8. Fill oil and fuel as instructed in the motor’s instruction manual.

Clothing

When using the machine, wear close-fitting work clothes,

tough working gloves, ear defenders and non-slip boots with

steel toecaps.

Be extra careful to stay away from rotating parts while working.

Use

Before using the machine, remove all foreign objects from the vicinity. Stones, glass,

branches and similar items can damage the tiller. Also check that bolts on the tiller are

tightened.

Start:

Set the throttle to fully open.

Follow motor start instructions.

Stop:

Set the throttle to minimum gas.

Follow motor stop instructions.

The black handle is used to move the tiller forwards. The red handle is used to move the tiller

backwards. Take care not to operate the tiller in reverse when standing with your back to an

object, for example, a tree or wall. Always exercise extra precaution when backing up or

moving the machine backwards.

The tiller blades pull the machine forwards. In other words, the speed of the machine

depends on how much gas you give it. If you hold the tiller back, the blades dig into the

ground.

If the tiller has a tendency to dig down, there are several things you can do. The right and left

blade set can be changed. This means that the tiller will use the back of the blade to till, and

thus it will not dig down so easily. In addition, side guards can be fitted. This also helps

prevent the tiller from digging down.

The depth skid must always be placed in the top notch if this is the case. See also the section

on adjusting the depth skid.