Texas TX501 B 6 фрез Инструкция по эксплуатации онлайн [20/57] 13215

The tiller's speed is regulated not only by the speed of the engine, but also by the depth skid,

which is situated behind the machine.

Do not till very wet soil, as clods of earth will be formed, and these are difficult to break up.

Dry and hard soil may need to be tilled twice.

The outer blades can be removed if the tiller is to be used between narrow rows of plants and

crops. This reduces the tilling width.

The ground can be tilled in two directions, thus achieving optimum tilling.

Figure 14.

When the engine is running, do not pull the handle for forward speed and the handle

for reverse speed at the same time! This will damage the transmission. Always release

one handle before the other is used. Always wait until the blades have stopped

rotating before using the other handle.

It is important that you do not try to hold back the tiller. Using the machine must be a

comfortable and relaxing experience. Always hold both handles securely.

Do not overload the tiller. Always use it with care.

Use the toolbox underneath the breast plate to store tools and the like.

Figure 13.

Adjusting the depth skid

The depth skid can be adjusted for tilling at 3 different depths. The deeper the depth skid sits

in the soil, the deeper the tilling blades will work and the slower the machine will advance.

Using the right tilling depth will lighten your workload. The depth skid will need to be adjusted

to suit the ground conditions, and we recommend that you make several attempts to see how

deep the depth skid should be before deciding which setting works best.

Adjust the depth skid by pulling it backwards and up until it reaches the preferred height.

Position the depth skid vertically and lower it into one of the notches. The depth skid can be

adjusted to suit various tilling depths. The deeper into the ground the depth skid goes, the

deeper the tiller will work. The right setting depends on the ground conditions.

Figure 2.

Adjusting the support wheels

The rear wheel set is mounted on the machine. It can be adjusted to the required height by

pressing the operating handle on the left side of the machine with your foot. Push the handle

to the left.

Figure 2a.

Alternatively, use the locking clamp on the right side of the machine. Pull the clamp out and

move the wheel ring up or down.

Figure 2b