Antari S-120 Инструкция по эксплуатации онлайн [3/14] 1268

Unpacking & Inspection

Open the shipping carton and verify that all equipment necessary to operate the system

has arrived intact. Accompanying the S-120 foam machine should be a hanging bracket

and fluid tank. If any equipment is missing contact your ANTARI dealer immediately.

Before beginning your initial setup on the ANTARI Foam Machine, make sure that there is

no evident damage caused by transportation. In the event that the unit’s housing or cable

is damaged, do not plug it in and do not attempt to use it until after contacting your

ANTARI dealer for assistance.

Setup

♦ Remove all packing materials from shipping box. Check that all foam and plastic

padding is removed, especially in the nozzle area.

♦ Place the machine on a flat surface and remove the liquid tank cap.

♦ Fill with ANTARI Foam Liquid or other dealer-recommended high-quality water-based

snow or foam fluid. Any other types of fluid can damage the unit. When filled, place

cap back on liquid tank.

Installation

The Foam Machine may be installed at floor level or suspended overhead. Install the

Foam machine in a well-ventilated area. Never cover the unit’s vents. In order to

guarantee adequate ventilation, allow a free air space of at least 20 cm around the sides

and top of the unit. Install the device out of the public area. Please consider that liquid may

be spilt during operation around the device. The resulting slippery surface can cause

accidents. Position output of foam away from persons. The minium distance should be

1.5 m. Only install the machine on scratch resistant and water resistant surfaces.

Please make sure that the inclination angle does not exceed 15°.

DANGER OF FIRE!

When installing the device, make sure there is no highly-inflammable

Material (decoration articles, etc.) within a minimum distance of 0.5 m.

This device is constructed for a standing installation only. If the device is to be installed

overhead, the following safety instructions are binding:

The installation of the device has to be built and constructed in a way that it can hold 10

times the weight for 1 hour without any harming deformation.

DANGER TO LIFE!

Please consider the EN 60598-2-17 and the respective national norms during

the installation! The installation must only be carried out by an authorized

dealer!

The installation must always be secured with a secondary safety attachment, e.g. an

appropriate catch net. This secondary safety attachment must be constructed in a way that

no part of the installation can fall down if the main attachment fails.