Kramer RC-76R Руководства по эксплуатации онлайн [9/23] 139614

RC-76R/RC-78R - Overview

Feature

Function

RESET Button

Press to reset to factory default definitions:

IP number  192.168.1.39, Mask – 255.255.0.0,

Gateway – 0.0.0.0

First, disconnect the power supply and then connect it

again while pressing the Reset button. The unit

powers up and loads its memory with the factory

default definitions and erases all stored preset

RS-232 (2) Terminal Block

Connector

Connects to a PC or the remote controller

RS-232 (1) Terminal Block

Connector

Connects to a PC or the remote controller

Program Switch

Slide the switch to the left when programming the

unit; slide to the right for normal operation

RS-485 Terminal Block Connector

Pins B (-) and A (+) are for RS-485;

Pin G may be connected to the shield (if required)

GPIO/GND Terminal Block

Connector

Connect to various sensors, switches, LEDs, or

relays

RS-485 Terminator Switch

Slide the DIP-switch up to terminate the RS-485

line with a 120Ω load; down is for no termination

K-Net Terminator Switch

Slide the DIP-switch up to terminate the K-Net line

with a 120Ω load; down is for no termination

Button Cover Plate Mounting

Screws

2 screws that hold the button cover plate to the

body of the device. Remove to access the buttons

(see Figure 6)