B.Well wa-88 Инструкция по эксплуатации онлайн [13/36] 150114

5.4. Measuring procedure

After the cuff has been appropriately positioned and the setting of the pre-

ssure pre-selection has been undertaken, the measurement can begin:

a) Press O/I

button to put the device into operation.

b) Press the START-button, – the pump begins to inflate the cuff. In

the display, the increasing cuff-pressure is continually displayed.

c) After reaching the inflation pressure, the pump stops and the

pressure slowly falls away. The cuff-pressure (large characters)

is displayed during the measurement. When the device has

detected the pulse, the heart

symbol in the display begins to

blink and a peep tone is audible for every pulse beat.

d) When the measurement has been concluded, a long peep tone

sounds. The measured systolic and diastolic blood-pressure

values as well as the pulse frequency are now displayed.

Example (Fig.): Systole 125, Diastole 73, Pulse 75

The measurement results are displayed, until you switch the device

off. If no button is pressed for 5 minutes, the device switches auto-

matically off, to save the batteries.

5.5. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for any

reason (e.g. the patient feels unwell), the O/I

button can be

pressed at any time. The device then immediately lowers the cuff-

pressure automatically.

5.6. Memory – storage and recall of the measurements

The blood-pressure monitor automatically stores each of the last 30

measurement values.

By pressing the MEMORY

button, the last measurement (MR1)

as well as the further last 29 measurements (MR2, MR3, ..., MR30)

can be displayed one after the other.

(MR1: Values of the last measurement)

(MR2-MR30: Values of the measurement before MR1)

istruction_All.indd 11 13.04.2006 16:06:54