Gorenje ogb100seddb6 Инструкция по эксплуатации онлайн [14/116] 153999

Protection against freezing:

- Use the key and select the operating mode (yellow control lamp under is on)

- The regulator is set to temperature 7ºC – shown on the display

Cost saving operating mode:

- Use the key and select the operating mode (yellow control lamp under is on)

- The regulator is set to temperature 55ºC – shown on the display

Manual temperature setting:

- Use the key and select the operating mode (yellow control lamp under is on).

- The display always shows the last setting of the water temperature; except on rst turn on

of appliance when factory setting 35ºC is displayed.

- Use the or key to select new temperature. By pressing the key you increase/

decrease the temperature by 1ºC. Holding the key will speed up the process.

- After required temperature is set display ashes for 3 seconds and then shows the current

temperature again.

- In case of interruptions in power supply, the appliance resumes operating with the settings

adjusted before the interruption.

INDICATION:

• Control lamps:

- Heating element operation : Green control lamp:

- the heating element is on – the lamp is on

- the heating element is off – the lamp is off

- Mg anode : Red control lamp:

- the lamp is off – anode is active

- the lamp is on – anode may be worn out

Warning! Whenthewaterheaterisoutofuseforlonger

periodoftime,thesignallampmayindicatethattheMg

anodeiswornoutinspiteofthefactthattheMganode

isstillactive.Inthiscaseopenthehotwatertap(fresh

waterowintowaterheater).Ifthesignallampswitches

off,thewaterheateroperationisnotimpaired.Ifnot,call

thenearestauthorizedserviceprovider

- Water heater operation: Yellow control lamps:

- protection against freezing – the lamp is on or

- cost saving temperature setting – the lamp is on or

- manual setting– the lamp is on