Kaiser W 34208 NTL Инструкция по эксплуатации онлайн [10/64] 16900

Max 900 mm

Min 600 mm

Connecting the drain hose

• Connect the drain hose 1 to the drain pipe 2

(diameter: 40 mm min.), or let it run directly into

the sink 3.

Use the special plastic hose support 4 which is

delivered with the appliance.

• Make sure that the hose is free from being bent or

flattened.

The free end of the hose must be at a height of 400 to

1000 mm and must not be immersed.

Disconnecting from water supply and sewerage

• To disconnect the Aqua-Stop inlet hose, cut off

water supply by turning off the faucet, screw out

the nut of the safety inlet hose which adjusts it to

the faucet.

• Put the hose into the special storage

compartment at the back of the dishwasher.

In case the free end of the hose is put directly into the

sink, pay attention to the following:

If the sink is mounted at the height of 100 cm from the

floor, the excess water cannot be drained directly into

the sink.

To drain the excess water from the hose in this case,

you need a pail or any other suitable container which

should be put below the sink at the side of it