Kaiser W 34208 NTL Инструкция по эксплуатации онлайн [8/64] 16900

CONNECTING TO WATER SUPPLY AND

SEWERAGE NETWORK

Connecting the Aqua-Stop inlet hose

The inlet hose

equipped with Aqua-Stop System 1 is

provided with double walls. The Aqua-Stop System

ensures blocking of water supply in case the inlet hose

has broken as well as if the air gap between the hose

itself and its corrugated shell is filled with water.

Connect the appliance to the water mains with new

hose sets only. Never reuse old hose sets.

Water pressure must amount to 0,05 MPa (min.) and 1

MPa (max.). In case the pressure is below the minimum

value, consult the Service Center.

• Pull the inlet hose completely out from storage

compartment located at the back of the

dishwasher.

• Connect the corner end of the inlet hose 2 to the

machine.

• While adjusting to the faucet, tighten the screw 3

of the safety inlet hose (3/4-inch thread).

• Before starting the washing machine, turn on the

faucet against the stop.

Connecting cold water

Connect the cold water inlet hose to the threaded 3/4-

inch connector. Make sure it is fastened tightly.

If the water pipes are new or have not been used for an

extended period of time, let the water run to make sure

that the water is clear and free of impurities.

If this precaution is not taken, there is a risk that the

water inlet can get blocked and damage the appliance.

Caution! Connection of hoses and cords as well

as placing the appliance into operation must be

made by a qualified expert only. Incorrect

installation may result in damage to persons and

property.