Polaris GAMMA 3.5 Инструкция по эксплуатации онлайн [15/23] 19396

 Before the operating please make sure that the unit is full of water and there is no air

inside.

 It is forbidden to use the unit without installation of the safety valve.

 Make sure the water inside the unit is not frozen. In case of frozen water do not use the

appliance.

 Do not use the unit if there is an air in supplying pipes.

 It is strongly recommended to use a filter in the supplying pipe. The manufacturer has no

responsibility for water pollution that can cause a damage of the unit.

 It is forbidden to remove the unit cover, it can cause an electric shock.

 Before plugging the device in outlet, please make sure, that the voltage in the ac source

agrees with technical characteristics of the appliance.

 The wrong use conflicting with the safeguards deprives the customer of the right for

warranty service.

 The appliance may be plugged in just the power net with ground connection. For your

safety, the ground connection must correspond with state rules and standards. Do not use

non-standard power supplies and connecting appliances.

 When plugging in, be sure, that the appliance is switched off.

 Do not use outdoors. Protect the unit from the extreme temperature, direct sunlight, sharp

corner shocks, moisture (never immerse into water). Don not touch with wet hands. In case

of contact with water immediately unplug it.

 In case of storing, cleaning or damaging please unplug the unit.

 If the power supply cord is damaged, it must be replaced by the manufacturer or its service

agent or a similarly qualified person in order to avoid a hazard.

 You should not repair the appliance by yourself. It must be done just by qualified

specialists of our service center.

 Only original spare parts may be used for repair.

 The heater is to be connected to a separate three-wire cable.

 The wires are to be connected according to the colors. It is necessary to assure the correct

and firm connection of yellow grounding wire. As the temperature of the supplying cable

in the entrance reaches more than 50˚С, heat-resistant cables are to be used.

 The unit is to be connected to a single wire power supply using a double pole

automatic switch rated for 16 А. The switch is to be set separately from the unit.

 A protective cutout device is to be installed to the power-supply circuit. Please

contact an authorized specialist.

 The grounding cable is to be connected directly to the ground of the customer’s grounding

source using a special separate cable.

II. Installation

The shower water heater is set on the wall at an altitude much greater than a person's

height. The water heater is completed with a bibb (tap-goose) and is fastened on the wall

above the sink. While using the water heater watch the water not to drop on it.

Installation arrangements are made on the account of the person who buys it.

Manufacturer is not responsible for the defects caused by wrong setting or careless

usage of the following operating manual.