MartinLogan ML-60i Руководство пользователя онлайн [6/40] 170110
![MartinLogan ML-60i Руководство пользователя онлайн [6/40] 170110](/views2/1198080/page6/bg6.png)
6
Protect Your Investment
• Use an amp that approximately matches the speaker's specified power handling.
• To avoid damage, turn down the volume if the speaker sounds like it is distorting,
sounds harsh, or the bass begins to break up.
• Tone controls and equalizers may increase the likelihood of distortion, especially at
high volumes. Use these settings sparingly.
Break-In
When you first begin to play your speakers, they will sound a bit bass shy. This is due
to the high quality, long-life components used in the drivers. Allow approximately 72
hours of break-in at 90dB (moderate listening levels) before any critical listening.
General Speaker Placement
Choosing a Mounting Location
Install the speakers between wall studs or ceiling joists being careful to avoid electrical
wires behind the wall's surface. Please note, ML-67i should only be used in-ceiling.
Wall Rigidity Results in Better Sound
Increasing the rigidity of your walls may improve sonic performance. To do this con-
sider adding cross bracing inside of the wall approximately 12-inch (30cm) above and
below the speaker.
Achieving Superior Imaging
These MartinLogan in-wall and in-ceiling speakers offer superb imaging and flexible
placement in nearly any location. However, for best performance and imaging place
speakers equidistant from one another and avoid physical obstructions between the
speaker and primary listening position.
Balancing Hard vs. Soft Surfaces Improves High- and Mid-Frequency Performance
Rooms that are “over damped” with carpeting, drapes, and other sound absorbers can
cause your system to sound dull and lifeless. On the other hand, rooms can have so
many hard surfaces that the system sounds like a gymnasium. Experiment by adding or
removing soft surfaces until you find a mix that sounds good to you.
Balancing Bass Output
Corner placement of these speakers will reinforce their bass output. If you require bal-
anced output across the entire audio spectrum avoid mounting these speakers in a corner.
Содержание
- Content check list 2
- Safety warnings and weee recycling 2
- Fig 1a 4
- Fig 2a 4
- Fig 2c fig 2b 4
- Fig 2e fig 2d 4
- Fig 3a fig 3b 5
- Fig 3d fig 3c 5
- Fig 3f fig 3e 5
- In ceiling mounting pictorial 10
- In wall mounting pictorial 11
- Specifications 16
- Specifications 18
- Grilles carrées supports de pré installation et boîtiers arrière à l épreuve du feu 23
- Fig 3a fig 3b 25
- Fig 3d fig 3c 25
- Fig 3f fig 3e 25
- Options de positionnement enceinte stéréo ml 62i 27
- Options de positionnement ml 60 ml 65i ml 66i ml 80i 27
- Options de positionnement enceinte ml 67i dirigeable 28
- Montage encastré au plafond illustration 30
- Montage encastré au mur illustration 31
- Installation 32
- Peinturer la grille d enceinte 33
Похожие устройства
- MartinLogan ML-62i Руководство пользователя
- MartinLogan ML-65i пользователя
- MartinLogan ML-66i Руководство пользователя
- MartinLogan ML-67i Руководство пользователя
- MartinLogan ML-80i Руководство пользователя
- MartinLogan ML-45AW Руководство пользователя
- MartinLogan ML-55AW Руководство пользователя
- MartinLogan ML-65AW Руководство пользователя
- MartinLogan ML-75AW Руководство пользователя
- MartinLogan ML-65R Руководство пользователя
- MartinLogan ML-75R Руководство пользователя
- MartinLogan ElectroMotion ESL Руководство пользователя
- MartinLogan ElectroMotion ESL X Руководство пользователя
- MartinLogan ElectroMotion C2 Руководство пользователя
- MartinLogan ElectroMotion FX2 Руководство пользователя
- MartinLogan Odyssey Руководство пользователя
- MartinLogan Preface Руководство пользователя
- MartinLogan reQuest Руководство пользователя
- MartinLogan Motion 10 Руководство пользователя
- MartinLogan Motion 12 Руководство пользователя