Home
Главная
SOLER&PALAU
decor-200 c
Инструкция по эксплуатации Страница: 10

SOLER&PALAU decor-200 c — электрическое подключение и управление вытяжными вентиляторами [10/44]

SOLER&PALAU decor-200 c Инструкция по эксплуатации онлайн [10/44] 186947

Electrical connection

The DECOR-100 is an extractor

designed for a single phase supply, with

voltage and frequency as indicated on the

rating plate of the unit. The units are

manufactured with double electrical

insulation (Class II) and therefore they do

not need an earth connection.

In addition to the switch shown in the

installation drawing/diagram, there must

be an All Pole switch in the fixed wiring

with a contact opening of min 3 mm.

The electrical cable must enter the

DECOR-100 through one of the cable

point (5).

Once the cable has been introduced

proceed using the electrical wiring

diagram applicable to the selected model.

DECOR S, C, SZ, CZ

These models use the following

diagrams:

Fig.3: Fan operating through the light

switch.

Fig.4: Fan operating through an

independent switch.

DECOR R, CR, RZ, CRZ

These models are fitted with an

adjustable timer. The timer enables the

fan to continue running for the selected

period after the switch has been turned

off.

Fig.5: Fan operating through an

independent switch.

Fig.6: Fan operating through a light

switch

The desired run-on time is selected by

means of an adjuster positioned on the

printed circuit board (fig. 7) and

accessible once the grille (1) has been

removed:

- To reduce the run-on time, turn

anticlockwise (min. 1 minute)

- To increase the run-on time, turn

clockwise (max: 30 minutes).

DECOR H, CH, HZ, CHZ

Models provided with an electronic

humidistat which can be adjusted from

60% to 90 % RH (relative humidity) and

with a timer, adjustable between 2 and 20

minutes.

Specific recommendations

- If changing the settings of the fan you

have to handle the controls located on

the PCB. These adjusters are fragile

and must be handled with care.

- For humidity measurement is correct

we need the fan is installed in an area

where there is good air circulation.

- Do not adjust the humidity outside the

room where the vent should be

installed.

- If the humidity level is consistently

above 90% RH, the fan will not stop.

Operation

Case 1: Automatic operation (fig.8)

Humidistat causes the extractor to

operate automatically when the humidity

level in the room is higher than the set

level. The extractor will stop automatically

when the humidity drops below the

selected level and after the selected

period set on the timer.

Case 2: Automatic operation as in case 1

with the facility to override the hygrostat

by means of the light switch (fig.6), when

the humidity level in the room is lower

than the selected level. In this case, the

extractor continues to operate for the

selected period set on the timer after the

switch light has been switched off.

ATENTION: When the humidity rise

above the selected value, the

automatic option takes precedence

over the manual and the unit cannot

then be switched off using a switch.

Содержание

Похожие устройства

Узнайте, как правильно подключить и настроить вытяжные вентиляторы с таймером и гигростатом. Подробные инструкции по эксплуатации и рекомендации.