Fein blk5.0 72323100239 Инструкция по эксплуатации онлайн [21/118] 192238

BLK2.0/BLK3.5: For template cuts, the template is traced

via the lower cylindrical part of the punch guide. The

clearance between template and the actual cutting edge is

2.5 mm.

The template should be at least 2 mm thick; the total

thickness of template and work piece may not exceed

5.5 mm.

BLK1.6: For cutting deep-channel trapezoidal sheet metal,

the optionally available profile set 160 can be mounted.

(see page 14)

Repair and customer service.

When working metal under extreme operat-

ing conditions, it is possible for conductive

dust to settle in the interior of the power tool.

The total insulation of the power tool can be impaired.

Blow out the interior of the power tool via the ventila-

tion slots frequently with dry and oil-free compressed air,

and connect a residual current device (RCD) on the line

side.

Lightly grease the sliding surfaces between die

holder and punch.

When the power tool’s power cord is damaged, it must

be replaced by FEIN or by an authorized FEIN Service

Agent, in order to avoid hazardous situations.

If required, you can change the following parts yourself:

Application tools

Warranty and liability.

The warranty for the product is valid in accordance with

the legal regulations in the country where it is marketed.

In addition, FEIN also provides a guarantee in accordance

with the FEIN manufacturer’s warranty declaration.

The delivery scope of your power tool may include only

a part of the accessories described or shown in this

instruction manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product

conforming with the relevant provisions given on the last

page of this Instruction Manual.

Environmental protection, disposal.

Packaging, worn out power tools and accessories should

be sorted for environmental-friendly recycling.

OBJ_BUCH-0000000022-001.book Page 21 Monday, January 31, 2011 9:06 AM