Fubag cold start 300/12 68827 Инструкция по эксплуатации онлайн [7/17] 193237

7. 12

Charging

Quick start

V output

1. When you are sure the battery leads are correctly placed, connect the power cord to the power

outlet to begin charging. .

2. battery by pushing the button 2 by pushing the button 3.

3. . Continue charging battery until charger's LCD displayer shows

“FUL”.

. Charging can be stopped at any time by disconnecting the supply cord or by push mode button 1.

6. If fault lamp 3 is on during charging , the reason for this is due to:

An interruption during charging, due to a loose connection or because the battery has ceased to

work.

The battery has become severe sulphated or dead and needs to be replaced.

The battery has a high self-discharge rate and may need to be replaced.

WARNING: DO NOT attempt to charge a frozen battery.

DO NOT leave the charger to battery without main power connected..

If the voltage of vehicle's battery is too low to start engine , the charger can provide 5minutes quick

charger to start the engine.

1. Press , then charger will charge the battery with 15Arate for 5 minut s.

2. Charger will give a Beep alarm.

3. Start the engine, if the engine fails to start, charge the battery for 5 more minutes before

attempting to crank the engine again.

Do not try to engine start a vehicle without a battery in it. You may damage the vehicle's system. If

the engine spins, but doesn't start after several starting attempts, there is a problem with the engine

of the vehicle other than its starting system. STOP cranking the engine until the other problem has

been found and corrected.

The charger has a 12V output socket on back. The maximum output current is 12A.

To use the output socket:

1. Insert the cigarette plug of appliance into the socket.

2. Press “12V DC output” button under standby mode

3. Turn on appliance

NOTE: The actual output voltage is 13.0-13.5 V , which is same as the voltage of cigarette socket in

vehicles when the engine is turned on. Make sure the appliance used is less than 140W.

Power ON

Set the tape and set mode

Indicator CHARGING light

button 6 e

www.fubag.ru

Omperator's anual

--6