Timberk swh fel1 80 v Инструкция по эксплуатации онлайн [10/40] 200905

www.timberk.com • electrical storage water heater

9. MAINTENCE

Fig. 8

Fig. 9

1. Check the power plug and outlet as often as possible. Secure electrical

contact and also proper grounding must be provided. The plug and outlet

must not heat excessively.

2. If the water heater is not used for a long time, especially in regions with

low air temperature (below 0°C), it is necessary to drain water from the

heater .

3. To ensure long reliable water heater operation, it is recommended to

regularly clean the internal tank and remove deposits on the electric heating

element of the water heater, as well as check condition of the magnesium

anode and, if necessary, replace it with a new one.

4. Preventive operations must be performed upon strict observance of the

operation manual and safety precautions.

5. The water heater is equipped with a thermal switch, which cuts off power

supply of the heating element upon water overheating or its absence in the

water heater. If the water heater is connected to the mains, but water is

not heated and the indicator doesn’t light up, then the thermal switch was

6. To drain water from the internal tank properly, water can be drained

through a composite relief valve (Fig. 8) (unscrew the composite relief valve

drain knob screw and set the drain knob to the upper position, at that hot

water tap must be open, and cold water supply valve must be closed).

7. Bear in mind to check serviceability of the relief valve every 14 days –

inspection method:

- turn the discharge lever to the left up until you feel the change of thread,

then water must start flowing from the valve’s hole. After checking the

water flow, return the lever to its initial position.

8. If necessary, wipe external surfaces of the heater by a damp cloth with

soap.

IMPORTANT!

The manufacturer provides an extended guarantee

for particular water heater components provided that

timely and proper routine maintenance is performed

by specialists of an authorized service center (see the

guarantee card).

IMPORTANT!

If these actions had no positive result or the thermal

switch turns off repeatedly during a short period of

time, then you should de-energize the water heater,

cut off water supply and contact your local Timberk

Authorized Service Center for a consult or repair of the

appliance.

switched off or not switched on. To reset the water heater to the operating

condition, it is necessary to:

- de-energize the water heater, remove the plate of the side / lower cover

for horizontal-type/vertical-type water heater respectively.

- for SWH FEL1 series vertical-type water heaters: unscrew retaining nut of

the thermal switch, fastened on the flange of the heating element, turn the

thermal switch and press the button, located in the center of the thermal

switch, until it clicks; Fig. 9;

- if the button is not pressed and there is no clicking, then you should wait

until the thermal switch cools down to the initial temperature.

Timberk swh fel1 80 v Инструкция по эксплуатации онлайн [10/40] 200905

Похожие устройства