Timberk swh fel1 50 v Инструкция по эксплуатации онлайн [9/40] 200906

www.timberk.com • electrical storage water heater

IMPORTANT!

To provide reliable operation and safe use of the

water heater, prior to the first run check if it is properly

connected to the 220~/50 V AC mains. The water

heater to be connected must be securely linked with

the earth circuit of your electric mains.

IMPORTANT!

Wall outlet should be rated on voltage not lower than

10А, electric main cabel with cooper section not

lesser then 3х1,5 mm

(for cooper).

Electric socket should be no lower, than 10A, power card with copper inner

part, cross-section of copper should be not less, than 3x1,5 mm

8. WATER HEATER CONTROL

Control panel

1. Thermostat handle

2. Power supply Indicator

3. Heating indicator

4. LED - display

Fig. 7

Water heater operation

1. Switching on

1.1 At first, open one of the hot water outlet valves, then open the cold

water supply valve. The electric water heater will start filling with water.

When water flows from the hot tap freely, it means the water heater is fully

filled with water and you can close the hot water outlet valve.

NOTE:

When setting temperature, having reached the

optimal heating position “ ” (+58°С (+/- 2°С), you

will hear a sound signal (for some models).

1.2 Plug the power cord into the outlet, at that an indicator light on control

panel.

2. Water heating temperature setting

2.1. Temperature can be set within the range 35°С-75°С, in increments

of 1°С.

2.2 The water heater automatically maintains water temperature. When

water temperature in the water heater reaches the temperature, set by the

NOTE:

During normal operation the cold water supply valve

must be set “open”.

user, the heating is automatically switched off. When water temperature

in the water heater drops to a certain level, the heating is automatically

switched off.

IMPORTANT!

Water may start dripping from the relief valve hole

during heating. It is impossible to avoid water leakage

and you must not prevent it since valve blocking

may cause rupture of the internal tank (in case of

equipment failure).

2 3

Timberk swh fel1 50 v Инструкция по эксплуатации онлайн [9/40] 200906

Похожие устройства