Texas Power Saw 3000 Инструкция по эксплуатации онлайн [11/31] 206382

Operation

IMPORTANT

Before the log saw is used, you must

make sure, that the saw blade is

turning the right way. See picture.

If the saw blade is turning the opposite

way, you can change the one fase by

using a screwdriver and turn it half way

round inside the power connector.

See picture.

It is important to have a clean working area. This is for your own safety. Make

sure that the wood is easy to obtain and reach. There should also be good

space to stack the cut wood.

Gain good footing and carry all kinds of protection such as guard, safety

goggles, ear protection and gloves.

Only one piece of wood must be laid on the saw at a time, regardless diameter

(max diameter 180 mm).

It is important that the blade reach max speed before approaching the log. If the blade

does not reach the maximum speed before use, the saw can have difficulties to saw

through the log. If this happens, remove the log from the blade and let the engine get the

blade up to speed again.

Maintenance

The log saw is almost maintenance free.

Always store the log saw in a dry area. Even though the saw has been treated for rust, it

may start to rust when exposed to too much damp. After use wipe the log saw clean with a

brush. Apply a thin layer of oil using an oily cloth to protect the machine from rust.

Always disconnect the current when adjusting, repairing or maintaining the

Power Saw.

Pay attention to the cable. It must be whole and without faults.