Crunch 213B Инструкция по эксплуатации онлайн [18/22] 23389

Follow these instructions to use the hook-and-loop tape.
1.Use a damp cloth to thoroughly clean both the bottom of the detector and the
dashboard.
2.Peel off the tape's paper backing and apply the tape to the bottom of the detector.
3.Remove the paper backing from the other side of the tape and press the detector
onto the dashboard.
Windshield Mounting
The supplied windshield bracket and suction cups let you quickly mount the detector to
your vehicle's windshield.
Follow these steps to use mounting bracket kit.
1.Install the suction cups onto the bracket by fitting them into their holes.
2.Attach the bracket to windshield.
3.Attach Detector to bracket.
4.Bend bracket for correct detection angle (if necessary), do not use the CRUNCH
213B to bend bracket.
5.Plug power cord DC12V into detector.
6.Plug power cord into cigarette lighter.
Cautions: Some new models of cars have a plastic safety coating which is applied to the
windshield. The suction cups may leave permanent marks on the windshield once they
are removed. Check vehicle owner's manual to see if your car has the plastic safety
coating.
Connecting the Power
The detector is designed to operate on most DC12V negative ground vehicle electrical
systems. The power cord provided with the detector has a cigarette lighter socket plug at
one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the detector.
2. Insert the other end into the cigarette lighter socket of your vehicle.
If the detector does not operate when you turn it on, remove the adapter from the
cigarette lighter socket and carefully check the socket for debris. Also, check the fuse in
the adapter and your vehicle's fuse box.
Replacing the Fuse
If the detector CRUNCH 213B stops operating, the fuse in the cigarette lighter plug might
be blown. If it has blown, follow these steps to replace it:
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has blown. If it has, replace it.
OPERATION
Power on and Self-Test
To turn the detector on, connect power and turn the On/Off volume control away from
you until it clicks.
When powered up, the detector sounds a distinctive tone for each signal and flashes in
18

Содержание

Скачать
Случайные обсуждения