Home
Главная
Saturn
Машинка Для Стрижки
ST-HC0360
Инструкция по эксплуатации Страница: 5

Saturn ST-HC0360 Инструкция по эксплуатации онлайн [5/44] 259723

Saturn ST-HC0360 Инструкция по эксплуатации онлайн [5/44] 259723

4

Using for the first time

1. Oil the cutting set.

2. Connect to the mains.

3. Switch the equipment on

using the on/off switch and, after use,

switch it off again.

Note: The audible click that can

sometimes be heard when switching

the equipment on is a result of the

drive unit switching on; this is

completely normal. A slight warming of

the equipment and vibrations during

use are also completely normal.

Service life – 3 years.

Cutting-length adjustment

With the adjustment lever at the side,

the cutting length can be steplessly

adjusted, even during operation.

• Lift the adjustment lever

upwards-minimum cutting length.

• Lower the adjustment lever-

maximum cutting length.

Cutting with attachment combs

Depending on the desired haircut, the

equipment can be operated with or

without attachment comb. To this end,

the cutting-length adjustment lever

has to be raised. Depending on the

model, attachment combs#1(3mm),

#2(6mm), #3(9mm) or #4(12mm) are

included in the scope of supply.

Attaching/removing an

attachment comb

• Place the attachment comb

onto the cutting edge of the cutting set

and press it down onto the cutting set

in the direction of the housing until it

clicks into position.

• The attachment comb can be

easily removed by lifting the hook.

Cleaning and care

• Do not immerse the

equipment in water!

• After each use, remove cut

hairs from the cutting set using the

cleaning brush.

• Wipe the equipment only with

a soft or slightly damp cloth.

• Never use solvents or

scouring agents!

• The cutting set can be cleaned

with a special hygienic spray.

• Do not use any other cleaning

agents.

• For long-lasting good cutting

performance, it is important to oil the

cutting set frequently. Use only

cutting-set oil.

• Cutting set oil and hygienic

spray are available from your dealer or

our Service Centre.

• If the cutting performance

deteriorates after long use despite

regular cleaning and oiling, the cutting

set should be replaced.

• Use the blade guard when the

equipment is not in use.

• Always store the equipment

with the blade guard in place.

Changing the clipping comb and

clipping blade

1. Switch off the equipment

using the on/off switch.

2. Disconnect from the mains.

Undo both screws on the cutting set,

remove the clipping comb and clipping

blade.

• When assembling, the clipping

comb and clipping blade should be

aligned as follows.

3. Raise cutting-length

adjustment lever-shortest cutting

length (Fig.a).

Похожие устройства

Случайные обсуждения

Ответы 1

Куда заливати масло

4 года назад