Pioneer VSX-420K Инструкция по эксплуатации онлайн [43/136] 2756
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Pioneer VSX-420K Инструкция по эксплуатации онлайн [43/136] 2756

Pioneer VSX-420K Инструкция по эксплуатации онлайн [43/136] 2756
Additional information 09
43
En
English
Français
Italiano
Español
Nederlands
Deutsch
Considerable noise in radio
broadcasts.
• Connect the antenna (page 23) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 23).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing
noise).
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 23).
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 14).
• Refer to Speaker setting on page 33 to check the speaker settings.
• Refer to Channel level on page 34 to check the speaker levels.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 33 to YES
or PLUS.
• Switch the LFEATT (LFE Attenuate) on page 31 to LFEATT 0 or
LFEATT 10.
The PHASE CONTROL feature
doesn’t seem to have an
audible effect.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see Speaker Distance on page 35).
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back.
•
Make sure the player’s settings are correct and/or the DTS signal out
is on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to C1/O1/O2 (DIGITAL) (see Choosing the
input signal on page 26).
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Problem Remedy
VSX-420_SY_En.book 43 ページ ２０１０年３月１９日　金曜日　午前９時３７分

Похожие устройства

Скачать