Dimplex Danville Brass FB2 Инструкция по эксплуатации онлайн [7/28] 277309

Installation Instructions

Before installing this appliance in an existing chimnney, we recommend that;

1. You have your chimney cleaned by a competent chimney sweep.

2. You block o the chimney  ue.

This procedure is important for the e cient operation of the heating unit and will also reduce heat loss up the chimney.

Installation.

Ensure that all packing items are removed (read any warning labels carefully).

Retain all packing for possible future use e.g. in the event of moving or returning the appliance to your supplier.

To install the appliance;

Manual Controls.

The Opti-myst manual controls are located beneath the hinged canopy. Raise the canopy to access the controls. (See Fig.2 for

Manual Control lay out)

Switch ‘A’:- Controls the electricity supply to the Fire.

Note: This switch must be in the ‘ON’ ( I ) position for the Fire to operate either with or without heat.

Switch ‘B’:- Press

operate immediately it will take a further 30 seconds before the  ame e ect starts.

Turning the control knob Anti Clockwise increases the  ame e ect, turning the control knob Clockwise will decrease

When the water in the tank and in the sump runs out the main lamps will go out. See instructions under ‘Maintenance’, ‘Filling

the water tank’. When this procedure is complete, the main lamps will illuminate but it will take 30 seconds before the  ames

Setting the Thermostat

Plug in and switch on the  re to the full heat setting. Turn the Control Knob ‘C’ fully clockwise (max temperature setting) to

warm the room rapidly. When the room temperature has reached the desired level, turn the thermostat knob back slowly until

you hear the thermostat just click o . The heater will then maintain the room temperature at the chosen level.

remove any obstruction that may be restricting the heat outlet, then continue normal operation.

Caution: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied

through an external switching device, such as a timer, or connected to a switch that is regularly switched on and o by the

utility.

2