Waring MX1000XTXEE Инструкция по эксплуатации онлайн [7/36] 278643

REPROGRAMMABLE STATIONS

1. There are 4 Program buttons for four reprogrammable beverage stations

for easy operation and consistent results. The factory-set stations are

programmed as listed below:

Liquid drinks

Frozen drinks

Ice cream drinks

Smoothies

2. To run any of the above preset programs, blender must be in

STANDBY mode.

3. Press desired Program button to start the blender. The motor will run at

the preset speed within the preset blending time. The LCD will show time

remaining. Once the blender counts down to 0, the motor will stop

running and the blender will return to STANDBY mode and prompt

“PRESS ANY BUTTON TO BLEND”.

NOTE: To terminate a blending program, simply press START/STOP

button or any of the Program buttons. After doing this, the blender will

return to STANDBY mode and LCD will prompt “PRESS ANY BUTTON

TO BLEND”.

REPROGRAMMING BEVERAGE STATIONS

Users can add 4 new programs to meet their needs. A program can

consist of several sections, each with a different speed and running time.

For example,

can be replaced with a new program that has 3 sections,

as shown below:

Section 1: speed = 75%; time = 30 seconds

Section 2: speed = 100%; time = 20 seconds

Section 3: speed = 50%; time = 20 seconds

The program has the following limitations:

Speed: 15% to 100%

Time: 5 to 90 seconds

Total running time in a program cannot exceed 90 seconds, i.e., sum

of the sections cannot be longer than 90 seconds.

NOTE: The

button will act as the enter key to proceed to next step

during the reprogramming process.

1. To enter new program, press both Speed Up

and Speed Down

buttons simultaneously while unit is in STANDBY mode. The blender will

enter new programming mode and the LCD will prompt “ADD NEW

PROGRAM”.

2. Next, you will need to set values. Press the Program button you want

to replace (i.e., 1... 4). The LCD will prompt “USE UP/DOWN TO SET

SPEED: 25%”.