Stadler Form Oskar Lime Инструкция по эксплуатации онлайн [7/27] 280635

ton (9) is blinking. After changing the filters, press the reset button (9) for
5 seconds until the blue LED is fully lighted again.
7. You can use the Oskar air humidifier to distribute fragrances in the room.
Please be as economical as possible in the use of fragrances, because ex-
cessive quantities may lead to malfunctions and damage to the appliance.
To use fragrances, remove the fragrance container (12) from the filling
opening (11). Place no more than 2–3 drops of fragrance in the container
and replace it in the space provided in the filling opening. If you wish
to change the fragrance, you can wash out the fragrance container and
fleece under running water.
8. If you wish to top up with water during operation, you can open the filling
opening (11) by pressing on it (Push to open). You can then refill the ap-
pliance using a water can or water bottle without having to switch it off.
PLEASE NOTE: If you are operating the appliance with fragrances, remove
the fragrance container before refilling to prevent water getting into it.
Should this nevertheless occur, it will be necessary to remove the water
container (2) and rinse it. Fragrances should not be permitted to enter the
water tank, since they might destroy the plastic.
Important information
Humidification with an evaporator takes time. This means that it usually
takes more than 23 hours to reach the desired humidity. If you operate
the humidifier in a very dry environment we recommend to operate it on
humidity level 5 and speed level 2 to reach a maximum amount of humidity
in a short time.
Cleaning and cassette replacement
Prior to any maintenance work and after each use, switch off the appliance
and withdraw the mains cable from the socket.
Never immerse in water (risk of short circuit).
External surfaces should only be wiped off with a damp cloth and then
dried well.
Every 2 weeks: To clean the inside, remove the filter cassettes and
descale the lower part if necessary. After descaling, thoroughly rinse the
lower part and then dry it before putting the air humidifier into operation
again.
For hygienic and optimum operation of the air humidifier, the filter cas-
settes should be replaced at least every two months. If the filter cas-
settes remain in use for longer than this, on the one hand the humidity
output may decline severely and on the other, the anti-bacterial action of
the cassettes can no longer be guaranteed. The filter cassettes can be
obtained from the dealer where you purchased your Oskar.
Ionic Silver Cube ™
The Ionic Silver Cube (15) prevents the growth of germs and bacteria in the
humidifier due to the continuous release of silver ions. The use of the Ionic
Silver Cube leads to a hygienic room climate. The lifetime of the Ionic Silver
Cube is around one year. We therefore recommend that you replace the Ionic
Silver Cube at the beginning of every humidifying season. The Ionic Silver
Cube starts working as soon as it comes into contact with water, and also
works when the unit is switched off.
Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
The appliance is not splash-proof.
For indoor use only.
Do not store the appliance outdoors.
Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
Setting up / operation
1. Place Oskar on a flat surface in the desired area. Plug the mains cable (3)
into a electric socket. Use the filling opening (11) to fill the lower part (2)
with water up to the maximum mark (14), either at a water tap or with a
watering can. When you have filled the lower part at the tap, carefully fit
the upper part (1) to the lower part (2).
2. Start the appliance by pressing the on/off switch (5). The blue LED should
then light up. If a red pilot lamp (10 and 14) lights up however, this indi-
cates either lack of water in the appliance or failure to seat the upper part
correctly on the lower part.
3. By pressing the speed level selector button (6) you can change the humid-
ity output (a blue lamp for normal evaporation, two blue lamps for high
evaporation).
4. You can use the hygrostat to set the desired air humidity. To do this, press
on the hygrostat button (7). You can choose between the following lev-
els: 40 % relative air humidity (1 blue lamp), 45 % (2 blue lamps), 50 %
(3 blue lamps), 55 % (4 blue lamps), constant operation (5 blue lamps). If
the lamps are flashing, this indicates that the desired air humidity has al-
ready been reached. Please note that the hygrostat needs about 3 second
to measure the current humidity in the room. The hygrostat switches on
automatically once the relative air humidity in the room sinks below the
preset value. We recommend that you set your room humidity to 45 %
(comfort range).
5. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (8). You can choose
between three different modes:
Normal mode (default mode)
Dimmed mode (push once)
Lights-out mode (push twice)
By pushing the dimmer button once more, you can go back into normal
mode.
If there is no water in the appliance, the red LEDs (10 and 14) light up in all
modes (normal and night mode). The red light can not be dimmed.
6. Oskar has a reminder function for filter change. At first use timer will be
set automatically. After a whole operating duration of two months the
filters need to be changed. In this case, the blue LED above the reset but-

Похожие устройства

Скачать