Lelit Anita PL042TEMD Инструкция по эксплуатации онлайн [7/28] 282055

Pag. 7

English

26. Insert the strainer holder (8) in the retaining ring (5) and turn it hard to the right; place the cups on the

removable cup rest (7).

27. Position the lever switch (13) on coffee mode and lift up the pump switch (26). The manometer (25) will

show the reached pressure, between 8 and 14 bar.

30. Check that the water tank (1) has been filled in with water by looking at the water level indicator.

31. Press the on/off switch (11): the indicator light of the switch (11) will come on. Do this operation only if

the machine is off. If it’s on pass to the following point.

32. As soon as the PID’s display shows the set temperature and the indicator light (14) goes on, the machine

is ready for use.

33. Fit the pod filter (18) into the strainer holder (8) that has been warmed up by leaving it attached to the

brewing group as described in point 7.

34. Open the single packed pod not damaging the pod.

35. Place the pod in its filter (18).

Steam:

40. Check that the water tank (1) has been filled in with water by looking at the water level indicator.

41. Press the on/off switch (11): the indicator light of the switch (11) will come on. Do this operation only if

the machine is off. If it’s on pass to the following point.

42. Position the lever switch (13) on steam mode. NB: the PID’s display will automatically show the writing

STE and alternatively the set temperature degree for steam. The PID is already set from the producer on

125°C, i.e. the ideal temperature for steam distribution. (If you want to change the PID’s temperature,

47. IMPORTANT: after you have frothed your milk, reopen the steam/hot water knob (4) and position the

steam switch (13) on hot water, and lift the pump switch up (26). When the water flows out of the steam

tube (6), close the steam/hot water knob (4) again and at the same time push the pump switch down (26)

and re-position the switch (13) on coffee again. Clean carefully the steam/hot water tube (6). This

operation is needed in order to restore the water circuit inside the machine’s tubes.

Hot water:

48. Check that the water tank (1) has been filled in with water by looking at the water level indicator.

53. Hot water will flow out from the steam arm (6) immediately.

54. Once you have got the desired quantity of water, repress the switch (26) and close the steam/water knob

(4).

55. After obtaining hot water from the arm (6), make sure that there is still water in the tank (1).