Schaub Lorenz SLD WE6800 Нержавеющая сталь Инструкция по эксплуатации онлайн [15/20] 299848

On/Off Button: used to start and stop the motor. In the beginning, the motor runs in 2

cycle. The number

of cycle is represented by bar levels and the rotation speed of the fan shown at the left-side of the display.

Minus Button: the cycle of motor reduces until it reaches 1

cycle each time when it is pushed if the motor is

running. In addition, it is used to reduce the timer value. On the display, it is represented by the number of bars

and the number of rotation of the fan.

Plus Button: used to increase the cycle of motor each time when it is pushed until it reaches the highest

cycle level if the motor is running. In addition, it is used to reduce the timer value. On the display, it is represented

by the number of bars and the number of rotation of the fan.

Shutdown Timer Button: a 15 minute starting timer value will be displayed and the clock icon will flash for 5

times when this button is pushed while the motor is running. The clock icon will be displayed until the timer

value lapses. The motor will stop and the bulb will turn off, if it is on, when the timer lapsed.

Alarm Timer Button: a 5 minute alarm timer will be displayed as starting timer on the display and the bell

icon will flash for 5 times when this button is pushed independent of whether or not the motor is running. The bell

icon will be displayed on the display until the timer time lapses. The buzzer will ring for 20 seconds and the bell

icon will flash when the timer lapsed. The buzzer can be shut by pushing the alarm timer when it is ringing.

Being valid for both of them; the timer value can be adjusted to any value in-between of 1 minute and 9 hour 59

minutes by pushing MINUS or PLUS buttons while flashing. The timer value will increase or decrease very quickly

when the MINUS or PLUS buttons are held pushed. The current value of the timer will be displayed on the display

when the timer button is pushed while the timer is set. The started timer button is pushed one more time and it will

be reduced until the timer becomes zero by pushing MINUS button if the started timer is needed to be cancelled.

Bulb Button: used to turn on and off the bulb. The bulb will appear at the right-side of the display while it is on.

Filter Warning: the (CLEAN FILTER) message which expresses that the filter should be cleaned will appear on

the display when the motor runs for 60 hours. The beep sound will be heard and the (CLEAN FILTER) message

will appear for 1,5 seconds more when the M.on/off button is held pressed for 4 seconds.

Power On: the clock which is valid when the power failure occurred will be brought on the power on, and the

operation will continue in clock adjusting mode.

Adjusting the Clock: pressing the MINUS and the PLUS button in the same moment will let to enter into a clock

adjusting mode. During clock adjustment, a triangular icon in the right midst of the clock will flash on the display.

The clock is adjusted by MINUS and PLUS buttons. The clock adjusting mode will be exited if any other button is

pushed other than MINUS and PLUS buttons.

Returning to Factory Settings

A beep sound will be heard and the (Fac) message will appear on the display when the M. on/off, MINUS and

PLUS buttons are kept pushed for 4 seconds in the same moment, and the factory settings are returned.

The Factory Settings

RGB Display Lightening Color: Red-100, Green-100, Blue-100

Display Lightening: ON

Click (the key sound): ON

Bulb Option: ON