Timberk WHE 4,5 XTR H1 Watermaster I белый Инструкция по эксплуатации онлайн [12/36] 300592
![Timberk Watermaster III WHE 12.0 XTL C1 Инструкция по эксплуатации онлайн [12/36] 378138](/views2/1191744/page12/bgc.png)
www.timberk.com electric instant water heater
12
Connection to Electric Main
WATERMASTER I Series. Water Heater Models: WHE 3.5 XTR 1, WHE 4.5
XTR H1, WHE 5.5 XTR H1
1. The connection to the electric main is made with 1 m long electric
cable coming out from the device housing. If the cable length is in-
sufficient, it can be extended with the help of special sealed electric
contacts.
It is prohibited to use a plug and power receptacle when connecting
water heater to the main, except for model WHE 3.5 XTR H1.
2. Water heater shall be connected to AC electric main with 220 V volt-
age by a three-core electric copper cable with the minimum core
cross-section: for model WHE 3.5 XTR H1 3x1.5 mm2 and 16 A cir-
cuit breaker; for models WHE 4.5 XTR H1, WHE 5.5 XTR H1 3x2.5
mm2 and 25 A circuit breaker. In the event of wire cross-section in-
crease it should be noted that water heater and electric cable shall be
located on a thermally insulated or heated wall.
3. Water heater shall be stationary (constantly) connected to the power
supply (except for model WHE 3.5 XTR 1), 220 V AC, with compul-
sory connection to a ground electric loop. Make sure that ground
loop resistance is < O.
ATTENTION!
It is prohibited to use a water heater without proper grounding.
WATERMASTER II Series. Water Heater Models WHE 5.0 XTN Z1, WHE 6.0
XTN Z1, WHE 6.5 XTN Z1, WHE 7.0 XTN Z1, WHE 8.0 XTN Z1
1. Power cable inlet is made at the smooth side of the device. It is pro-
hibited to use a plug and power receptacle when connecting water
heater to the main.
2. Water heater shall be connected to AC electric main with 220 V volt-
age by a three-core electric copper cable with the minimum core
cross-section: for model WHE 5.0 XTN Z1 3x2,5 mm2 and 25 A cir-
cuit breaker; for models WHE 6.0 XTN Z1, WHE 6.5 XTN Z1, WHE 7.0
XTN Z1 3x4 mm2 and 32 A circuit breaker; for model WHE 8.0 XTN
Z1 3x6 mm2 and 40 A circuit breaker.
In the event of wire cross-section increase it should be noted that
water heater and electric cable shall be located on a thermally insu-
lated or heated wall.
4. For connection to power supply:
- Remove the front panel by unscrewing 2 screws at the device sides,
- Strip the power cord ends by not less than 7-10 mm,
- Pass the electric cable via electric cable inlet opening 10 (see Fig.4)
at the rear part of the device,
- Remove the clamping plate holding the electric cable, do not lose
the positioning screws, make sure that the cable is not touching
sharp edges and hot surfaces,
- Connect the electric cable wires with junction block 8 (see Fig.4)
according to its marking,
- Make sure that securing screws are tightened correctly. Untight
connection may result in heating of wires,
- Install the electric cable plate into the main position with the help of
positioning screws, make sure that the cable cannot be pulled out,
- Check the tightness of connection of all internal electric contacts,
including detachable contact block and bolted connection at heating
elements.
If there are any loose items, fix and tighten them,
- Install the front panel and tighten 2 screws at the device sides.
WATERMASTER III Series. Water Heater Models: WHE 12.0 XTL C1, WHE 18.0
XTL C1, WHE 21.0 XTL C1, WHE 24.0 XTL 1.
1. Electric cable inlet is made at the rear side of the device.
2. Water heater shall be connected to AC electric main with 380 V volt-
age by a four-core electric copper cable with the minimum core
cross-section: for model WHE 12.0 XTL C1 4x2.5 mm2 and 3x25 A
circuit breaker; for model WH 18.0 XTL C1 4x4 mm2 and 3x32 A
circuit breaker; for models WHE 21.0 XTL C1, WHE 24.0 XTL C1 46
mm2 and 40 A circuit breaker in the event of wire cross-section
increase it should be noted that water heater and electric cable shall
be located on a thermally insulated or heated wall.
ATTENTION!
It is prohibited to use a water heater without proper grounding.
3. Water heater shall be stationary (constantly) connected to the power
supply (except for model WHE 3.5 XTR 1), 220 V AC, with compul-
sory connection to a ground electric loop. Make sure that ground
loop resistance is < O.
Содержание
- Electric instant water heater 1
- Instruction manual 1
- Models 1
- English 3
- English 5
- English 7
- English 9
- Fig 14 10
- English 11
- English 13
- English 15
- During use of the water heater scale may appear in nozzle openings of the shower spout this reduces efficiency of heating deteriorates water spray ing and increases water pressure in the heating vessel for prevention of such phenomena it is necessary to periodically clean the nozzle using household chemical agents and soft brushes do not use abrasive cleaning substances and inappropriate chemical agents a outer care switch off the appliance and allow it to fully cool down clean the outer surface of the appliance enclosure using a slightly moist ened soft cloth and then wipe it dry do not use abrasive cleaning sub stances b filter cleaning if water flow rate from the heater decreases it is necessary to clean the coarse filter installed at the cold water inlet to the water heater use the following procedure switch off the appliance and allow it to fully cool down shut off cold water feeding unscrew the cold water feed hose from the water heater remove the coarse strainer and flush it und 16
- Maintenance 16
- Possible causes 16
- Possible malfunctions and methods of their elimination are given in table 4 table 4 16
- Problem 16
- Troubleshooting 16
- Troubleshooting method 16
- Disposal upon expiration of service life the water heater shall be disposed for more details regarding disposal of the water heater please contact a representative of the local authorities service life of a device is 5 years 17
- Electrical schematic diagram 17
- English 17
- Power card 17
- Watermaster i series water heater models whe 3 xtr h1 whe 4 xtn z1 whe 6 xtr h1 whe 5 xtr h1 17
- Watermaster ii series water heater models whe 5 xtn z1 whe 6 xtn z1 whe 6 xtn z1 whe 7 xtn z1 whe 8 xtn z1 17
- Watermaster iii series water heater models whe 12 xtl c1 whe 18 xtl c1 whe 21 xtl c1 whe 24 xtl 1 17
- Www timberk com e instant water heater lectric 17
- Watermaster ii 3 4 23
- Watermaster iii 5 6 23
- Timberk www timberk com 32
- Watermaster i whe 3 xtr h1 whe 4 xtr h1 whe 5 xtr h1 33
- Watermaster ii whe 5 xtn z1 whe 6 xtn z1 whe 6 xtn z1 whe 7 xtn z1 whe 8 xtn z1 33
- Watermaster iii whe 12 xtl c1 whe 18 xtl c1 whe 21 xtl c1 whe 24 xtl c1 33
- Timberk 34
- Www btpart ru 35
Похожие устройства
- Timberk THU MINI 02 Инструкция по эксплуатации
- Timberk ECO SERIES TOR 21.1809 ACX БЕЛЫЙ Инструкция по эксплуатации
- Timberk ISLANDIA NOIR TEC.E5 M 1000 ЧЕРНЫЙ Инструкция по эксплуатации
- Boneco U7146 Инструкция по эксплуатации
- Timberk TCH A1B 2000 СЕРЫЙ, ЧЕРНЫЙ Инструкция по эксплуатации
- Valera SN 6000 Swiss Nano Rotocord черный/серый Инструкция по эксплуатации
- APC SRT96RMBP Инструкция по эксплуатации
- Timberk PRESTO ECO TEC.E0 M 2000 БЕЛЫЙ Инструкция по эксплуатации
- Timberk WHEL-7 OSC белый Инструкция по эксплуатации
- Timberk SWH RE9 50V 50 л белый Инструкция по эксплуатации
- Electrolux OPEA7553M Инструкция по эксплуатации
- Shindo MAYA 2M 50 SS/BG Инструкция по эксплуатации
- Electrolux EC2800AOW Инструкция по эксплуатации
- Timberk WHP 5 OS белый Инструкция по эксплуатации
- Timberk Allure THU UL 18 Инструкция по эксплуатации
- Zanussi ZCG 961218 X Инструкция по эксплуатации
- Timberk SWH SE1 30 VU 30 л белый Инструкция по эксплуатации
- Timberk TCR 510.HDA СЕРЫЙ, ТЕМНО-СЕРЫЙ Инструкция по эксплуатации
- AEG L57427TL Инструкция по эксплуатации
- Electrolux EKC954507X Нержавеющая сталь Инструкция по эксплуатации