Simfer M4558 Инструкция по эксплуатации онлайн [4/35] 302517

WARNINGS

Pay attention to minimum health and safety requirements.

If the current rate of the fuse in your installation is less than 16 Amp, make a qualified electrician

fit a 16 Amp fuse.

Keep the electrical cable of your oven away from the hot areas; do not let them touch the

appliance. Keep them away from sharp sides and heated surfaces.

Usage of your appliance creates moisture and heath in the room it is placed, make sure that your

kitchen is ventilated well. Maintain the natural ventilation ducts properly.

Do not touch hot parts with bare hands and keep children well supervised.

When the oven is hot never touch the oven glass by hand.

Before starting to use your appliance, keep curtain, tulle, paper or inflammable things away from

your appliance. Do not keep combustible or inflammable things in or on the appliance.

Use your oven production for cooking purpose. Please do not use except for purpose.

The pop-up knobs absolutely must be run push-off mode as following pictures for which models

have pop-up knob.

IF YOUR OVEN DOES NOT OPERATE

Please check the plug of power supply cord has a well connection with wall socket or not.

Please check the electric network.

Please check the fuse.

Please check power supply cord for any damage problems.

If you can not solve the problem, please apply manufacturer supplier services agent.

ELECTRICAL CONNECTION & SECURITY

Your oven is adjusted in compliance with 230-240 Volt AC, 50 Hz (for SA will be 220-240V,60

Hz), electrical supply, and requires a 16 Amp (for England 13 Amp) fuse. If the mains are

different from this specified value, contact an electrician or your authorised service.

Isolation switches for the oven must be accessible to the end user with the oven in place.

Should you need to replace the 16 Amp plug top (for England 13 Amp), please ensure you rewire

the plug as follows; wire to the terminal

wire to the terminal

wire to

Electrical connection of the oven should only be made using sockets with Earth system installed

(for England B.S. Approved sockets with Earth system), and in compliance with Regulations. If

there is no proper socket with Earth in place, immediately contact a qualified electrician. The

Manufacturer will not be responsible for damage or injuries that can arise because of inappropriate

supply outlets with no earth system.

If your electric supply cable gets defective, it should definitely be replaced by the authorized

service or qualified electricians in order to avoid from the dangers.

Electrical cable should not touch the hot parts of the appliance.

The oven should be using a well ventilation place and should be install on flat ground.

Please operate your oven in dry atmosphere.

- Brown Live

Blue Neutral

Yellow & Green Earth