Home
Главная
Makita
Сетевая циркулярная пила
5057KB
Инструкция по эксплуатации Страница: 6

Makita 5057KB Инструкция по эксплуатации онлайн [6/20] 307982

Makita 5057KB Инструкция по эксплуатации онлайн [6/20] 307982

6

ward while the blade is in motion or KICK-

BACK may occur. Investigate and take

corrective actions to eliminate the cause of

blade binding.

When restarting a saw in the workpiece,

center the saw blade in the kerf and check

that saw teeth are not engaged into the

material. If saw blade is binding, it may walk

up or KICKBACK from the workpiece as the

saw is restarted.

Support large panels to minimize the risk

of blade pinching and KICKBACK. Large

panels tend to sag under their own weight.

Supports must be placed under the panel on

both sides, near the line of cut and near the

edge of the panel as shown in Fig. 1.

To minimize the risk of blade pinching and

kickback. When cutting operation requires

the resting of the saw on the workpiece, the

saw should be rested on the larger portion

and the smaller piece cut off.

Do not use dull or damaged blade.

Unsharpened or improperly set blades pro-

duce narrow kerf causing excessive friction,

blade binding and KICKBACK. Keep blade

sharp and clean. Gum and wood pitch hard-

ened on blades slows saw and increases

potential for kickback. Keep blade clean by

first removing it from tool, then cleaning it

with gum and pitch remover, hot water or ker-

osene. Never use gasoline.

Blade depth and bevel adjusting locking

levers must be tight and secure before

making cut. If blade adjustment shifts while

cutting, it may cause binding and KICKBACK.

Use extra caution when making a “Pocket

Cut” into existing walls or other blind

areas. The protruding blade may cut objects

that can cause KICKBACK. For pocket cuts,

retract lower guard using Retracting Lever.

ALWAYS hold the tool firmly with both

hands. NEVER place your hand or fingers

behind the saw. If kickback occurs, the saw

could easily jump backwards over your hand,

leading to serious personal injury.

Never force the saw. Forcing the saw can

cause uneven cuts, loss of accuracy, and

possible kickback. Push the saw forward at

a speed so that the blade cuts without slow-

ing.

12.

Use extra caution when cutting damp

wood, pressure treated lumber, or wood

containing knots. Adjust speed of cut to

maintain smooth advancement of tool without

decrease in blade speed.

13.

Adjustments. Before cutting be sure

depth and bevel adjustments are tight.

14.

Avoid Cutting Nails. Inspect for and

remove all nails from lumber before cut-

ting.

Fig. 1 To avoid kickback, do support board or

panel near the cut.

Fig. 2 Do not support board or panel away

from the cut.

Fig. 3

Содержание

Похожие устройства