Proform 475 ZLE (PFEVEX23935) Инструкция по эксплуатации онлайн [19/24] 317351

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted.

To adjust the drive

belt, first use a

standard screw-

driver and carefully

pry the Accessory

Tray (50) upward

off the Right

and Left Shields

(48, 49).

Next, remove the M6 Bolt Set (67) from the Right

Upper Body Leg (5) and the Right Pedal Arm (9). Then,

gently move the Right Pedal Arm out of the way.

Next, remove the M8 x 20mm Screw (61), the Axle

Cover (44), and the M8 Washer (not shown) from

the Right Roller Arm (7) and the right Crank Arm (not

shown). Gently move the Right Roller Arm out of the

way. Then, use a standard screwdriver and gently

remove the Outer and Inner Crank Covers (52, 53)

from the right Crank Arm.

See EXPLODED DRAWING A on page 22. Remove

the M4 x 25mm Screw (68) and the M4 x 19mm

Screws (84) from the Right and Left Shields (48, 49);

make sure to note the location of each screw. Then,

gently remove the Right Shield.

Locate and loosen the M6 x 20mm Screw (25). Next,

tighten the M10 x 55mm Screw (20) until the Drive Belt

(55) is tight. Then, retighten the M6 x 20mm Screw.

Reattach the right shield, the outer and inner crank

covers, the right roller arm, the right pedal arm, and the

accessory tray.

52, 53