Vitek VT-3625 Инструкция по эксплуатации онлайн [5/28] 430
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Vitek VT-3625 Инструкция по эксплуатации онлайн [5/28] 430

Vitek VT-3625 Инструкция по эксплуатации онлайн [5/28] 430
ISO TYPE CONNECTOR
RCA jacks:
Line out:
: Red (right)
: White (left)
Line in:
: Red (right)
: White (left)
PLUG A
1.
2.
3.
4. Memory +12 V
5. Car Antenna Output
6.
7. +12 V (to ignition switch)
8. Ground (-)
Note:
(Plug A contact number 7) should be connected
to the ignition switch of the car in order to avoid
discharging of the car battery when the engine
is turned off and the battery is not being
recharged.
PLUG B
1. Right rear speaker (+)
2. Right rear speaker (-)
3. Right front speaker (+)
4. Right front speaker (-)
5. Left front speaker (+)
6. Left front speaker (-)
7. Left rear speaker (+)
8. Left rear speaker (-)
Maintenance
REPLACING THE FUSE
If the fuse burns out, check the connection to
power and replace the fuse. If the fuse burns out
again after being replaced then there may be
and internal malfunction. If this happens, con-
sult with your nearest service center.
Warning
Use a fuse of the indicated current level for each
wire. Using fuses with high current levels can
lead to serious damage.
Operating Instructions
1. On/Off ( )
The device turns on and off when this button is
pressed and held.
This device also turns on when any button is
pressed.
2. Selection
3. Volume up/down
Turn this knob (3) to adjust the volume. To
choose other functions, press the SEL button
(2) momentarily until the desired function
appears on the screen. Figure 1 shows the order
in which sound control functions are selected
using the SEL button.
Fig. 1 Sound control function selection
1. Volume 2. Selection 3. Bass 4. Treble 5.
Balance 6. Fader adjustment
Rotate the knob to set the Bass, Treble, Channel
Balance and Fader level.
TA SEEK /TA ALARM (2)
Press the SEL button for more than 2 seconds to
activate the function selector for traffic notifica-
tion messages.
The TA SEEK or TA ALARM functions can be
chosen by rotating the VOL knob.
2 sec.
TA SEEK mode:
If a newly tuned station does not transmit traffic
information within 5 seconds, the radio automat-
ically tunes to the next station that transmits
traffic information.
In TA search mode, the current station can be
switched to another station if the signal is weak,
because the device is searching for TP-stations
that have strong broadcast signals and are
transmitting TP-signal information.
TA ALARM mode:
With the TA search mode disabled, the radio will
sound and audible alert when traffic information
is about to be broadcast.
DPI Mask(2)
The selection mode for this function is activated
upon holding down the SEL button for more than
2 seconds.
MASK DPI mode: masks radio stations on alter-
native radio frequencies (AF) that have differing
program identifiers (PI) .
MASK ALL mode: masks radio stations on alter-
native radio frequencies with differing program
identifiers and the signal NO RDS.
USING THE RETUNE L / S FUNCTIONS (2)
Upon pressing the SEL button for more than 2
ENGLISH
5
3625_4l.qxd 29.03.05 16:39 Page 5

Похожие устройства

Скачать